New products

O-Ring Seal for Forward Gear Selector Shafts.Series 1 to 3, 1955-84.Typically 2 Required.Supersedes GT-241596, GT-237637.

Intermediate Gear Shaft for Series 1-2a. Up to Gearbox Suffix A; 1948 to September 1962. Supersedes GT-219470 GT-267794. For later shaft, see GT-59...

Retainer for Transfer Lever Rubber Grommet.Series 1-3 1954-84.

Drain Plug or Wading Plug, 1/4" BSP Oil Level Plug for Transfer Case, Series 1 to 2a to Gearbox Suff A, (1962). Note some use 1/8" BSP Plug, SC-FTC...

Gearbox Filler Taper Plug (also for 2.6L Water Pump)

Spring for Gearbox Forward Selectors 1948-84

Shim Washer for Rear of Gearbox Mainshaft.Series 1-3, 1948-84.

Dowel for Flywheel Locating Clutch all 4 Cyl to 1998

Selector Shaft for Reverse Gear 1948-71, Series 1-2a.Land Rover Genuine, New Old Stock.

Hinge Stop Assembly Reverse Gate Assy 1948-79 LR Gen

Hinge Stop Assembly Reverse Stop Genuine LR 1948-79

Bracket Gear Lever for Reverse Stop Springs S1-3 1948-79

Locating Pin for Main Gear Lever Series 2-3 OEM

Connecting Rod "Big End" Bearing Set .010 US.1955-58 Series 1 2.0L Spreadbore Engine.New Old Stock.

Connecting Rod Bearing Set .040 US.Series 1 1955-58 2.0L Gas Spreadbore Engine.New Old Stock.

T/Washer .0025 for Crankshaft 2.0L 1955-58 & Salisbury Diff

First Speed Gear on Layshaft for Gearbox Suffix C on (1965 to 1971).14-Tooth Gear.

Metal Cover for Top of Bell Housing Series 2-3

Rubber Gasket for Bell Housing Top Cover Plate 1958-84

Thrust Washer for Intermediate Gear Series 2a-3 64-84. OEM.

Screw for Gearbox Inspection Cover Plate 1/4" x 7/16" Whitworth. Series 1 through 3, 1948-84. Note: You are purchasing 1, not 10 as shown in the ph...

Retaining Plate -for Layshaft Bearing Gearbox Suff B 09/62-84

Castle Nut for Front of Layshaft Series 2a 1964-71 3/4" UNF

Main Bearing Set .30 .030" Under Size 2.25L Gas Series 2 1958-61 and Series 1-2, 2.0L Diesel.Note: These are NOS specific to the Series 2, 1958-61 ...

Bearing for Front Layshaft Gearbox Series 2a-3, 1964-84

Spacer for Layshaft 0.445" Series 2a-3, 1968-84

Gearbox Mounting Bracket (Foot on Transfer) RH Series 2a-3

O-Ring Seal for Intermediate Shaft Series 2a-3 1964-84

Retaining Clip for Speedometer Cable on LT230. OEM.For Defender, Discovery 1 and Range Rover Classic.Note: You are purchasing 1, not 10 as shown in...

Special Bolt for 4-Wheel-Drive Lever to Housing.For Series 1-3.Supersedes GT-233410.You may also require the Bushing for in the Lever, see GT-230086.

Drain Plug for Gearbox & Transfer Case & S2a Axle

Primary Shaft and Primary Pinion Series 2a Gearbox 1964-71 SPECIAL ORDER: Please note this item is special order and there will be a substantial pa...

Layshaft for Gearbox Suffix D & E, Series 2a 1966-70

Interlocking Plunger for Gear Selector Shafts

Locking Pin for Selector Shafts

Bearing for Primary Pinion (Front of Main Shaft) Gearbox Series 1-3

Stud for Gearbox and Transfer Case 1-3/4" 1948-84

Spring for Gearbox Reverse and Transfer Selector 1948-84

Shim for Intermediate Gear for Series 2a to 3, September 1963 to 1984.Quantity As Required. These are 0.005" shims.

Oil Seal for Primary Pinion Series 3 Gearbox

Detent Ball for Selector Shaft on LT230 Gearbox

Mainshaft Distance Piece (Bushing) 1-Piece. Series 1 to 3 Gearbox Suffix A. You can also use the later 2 separate pieces, GT-FRC4076 and GT-FRC4077...

O-Ring for Speedometer Pinion on LT230 & LT85

Circlip for Rear Output Flange Transfer Case LT95, LT230. OEM.

4 Wheel Drive Selector Rod for Series 1-3 1948-84.Note: This Uses 2x BN-3819 1/4" BSF Nuts, GT-561221 Spring, GT-215808 Clevis. If this is for an e...

Bearing for Front Layshaft Series 1-2a 1948-63 Suff A

Rubber Bushing for R380 Gear Knob & RRC TailgateLand Rover GenuineYou are Purchasing One (1)

Bell Housing for 2.25L 4 Cylinder Engine to Transmission For Series 3 Gearbox, Clutch Slave on Left-Hand Side. New Old Stock