Newest Products

Radiator for TD5 w/EGR from 2A622424 (2002) and Puma TDCi.For Earlier, see EC-PDK000100.

Knob for Ventilator Control on Dash Push-On Type.For Series 2-2a.Quality Re-Production Made in the UK.

Seatbelt Anchor Bracket Chassis Mount Galvanized.For Series 3. Mounts on the chassis under the tub,

Knob for Ventilator Control on Dash with Screw.Screw-On Type for Series 2-2a.Quality Re-Production Made in the UK.

Copper Nickle Fuel Pipe Flex Pipe to Carburetor.For Series 1 1948-58.

Copper-Nickel Fuel Pipe Sediment Bowl to Pump.For Series 1 1954-58.

Copper-Nickel Fuel Pipe Tank to Sediment Bowl.For Series 1 1948-58.Alternate Part Number: EF-239642.

Copper-Nickel Fuel Pipe Tank to Flex Pipe.For Series 2, 2.0/2.25L 1958-60.

O-Ring for Fuel Block.For Defender TD5 to 2001, Discovery 2 with the TD5 to 2001.

Accelerator Throttle Cable for Defender 90/110 with the 3.5L V8 Twin Carburetor, (including the NAS Defender 90 3.5L V8 Carb).You may require the c...

Accelerator Throttle Cable for Defender 110 2.25L RHD and 2.5L LHD Naturally Aspirated Diesel up to VIN:267061.30" Long.

Accelerator Cable Defender 110 LHD 2.25L Diesel. 46" Long.

Lower Dash Finisher for Left Hand Drive Defender.Supersedes BP-MTC6167.

Rotary Indicator Switch Black Plastic Lever 27mm Hole.Used on Series 1 and early Series 2 as the Turn-Signal Switch.This has 3 terminals. (Power in...

Rear Fulcrum Bracket with Top Link Ball Joint, OEM.Fits Defender, Discovery 1, and RRC.This is the OEM Ball Joint, SS-RHF500110, already pressed in...

Headlamp Pigtail Wire Harness.For Series 2-3, H4 Headlamp Plug with Bullet Connectors.

Spherical Bearing for Clutch CrossShaft and HandBrake.For Series 2/2a Clutch Cross Shaft and Left Hand Drive HandBrake Lever up to Suff C, (1948-Ap...

Felt Ring for Hand Brake and Clutch Cross-Shaft Bearings.For Series 2-2a Clutch, (2 Required), and Series 1-2a Left Hand Drive Handbrake Lever Shaf...

Complete Stainless Exhaust System Series 2a and 3, 88" 2.25L Gas 1961-84. This kit fits: Series 2A and 3 SWB 88" all gas models 1961-84. Right Exit...

Bonnet Hinge Kit Aluminium Billet Black PairFor Defender. With bolts and bonnet hinge bushings.

Bonnet Hinge Kit Aluminium Billet Black Pair.For Defender. With bolts and bonnet hinge bushings.

Nut Hex Cap M12-1.75 Metric Zinc for Various Uses.

Fuel Filler Tube Assembly for Diesel Defender 1999-2016. This requires grommet EF-WLR000020 to fix/seal in place (linked below).

Thermostat 88 Degree Fahrenheit for 300Tdi.For Defender, Discovery 1, and Range Rover Classic.OEM Waxstat. Made in the UK.There is no gasket betwee...

Rear Safari Door 3-Hinge Kit with Stainless Steel Fittings.Fits Series 2-3, (3 Hinge Rear Doors), and Defender.

Front Door Left and Right Hand Hinge Kit with Stainless Steel Fittings, Fits Series 3 and Defender. For a set of Front and Middle Row Door Hinges, ...

Front and 2nd/Middle Row Doors Left and Right Hand Hinge Kit with Stainless Steel Fittings. Fits Series 3 109" Station Wagon and Defender 110/130 S...

Wiring Harness for Fuel Injection. aka: Injector Wiring Harness.TD5 Defender and Discovery 2.

Washer Flat for Hard Top Side Panels and Various Uses.Series and Defender.

Plastic Rivet for Seat Strap Fastening to Metal Bottom Seat Cushions and for Fastening Plastic Corners to Metal Bottom Seat Cushions.For Late Serie...

Leather Strap for Seat Back 140mm Long, Package of 3. For Series 1-3. These are 40mm longer than the standard seat cushion strap TS-331974. We find...

Leather Seat Strap Series 1-3 for Seat Cushions. Be sure you have the Stud TS-MXC4657 (linked below top left) on the front of the Seat Box for each...

Clip Double Pipes to Chassis for Fuel Lines.For Defender up to 2006 and Range Rover Classic.

Foam Rubber Seal for the Top of the B Post to Roof on Series 2-3 or Defender Station Wagons.

Door Latch Assembly KIT Right Hand Defender 110/130 2nd Row Side Door All the bits needed to get that door closing properly.

Rear Door Trim Panel Clip Defender from 2A000001