Newest Products

Exhaust and Inlet Manifold Gasket - 4 Cylinder 2.25L Gas.For Series 2 to 3, and Defender 2.25 and 2.5L Gas Engines.

Gasket for the Inlet Manifold to the Exhaust Manifold.2.25L Gas Series 2-3 1958-84.

Timing Chain for 1.6L, 2.0L and 2.25L Series 1-3 (3-Bearing) 1948-80.Supersedes EP-09156, EP-9156 and EP-504375.For the 2.6L 6 Cylinder, or the lat...

Timing Chain for 2.25L Series 3 5-Bearing Engine 1980on, (Note: use with tensioner EP-ETC5190), 2.6L 6 Cylinder, and 2.5L Gas.For Earlier Chain, se...

Timing Chain Damper for 2.25L, 2.5L 2.6L Gas or 2.0L Diesel

Carburetor Zenith 361V Replacement Series 2a-3 2.25L April 1967 to 1984.Note: To replace a Solex Carb on an earlier 2 or 2a, you are going to need ...

Weber 34ICH Carburetor Kit. Includes Choke Cable, Gaskets. Direct Replacement for Zenith Carburetor from April 1967 to 1984. Made in Spain. To repl...

Weber 34 ICH Carburetor Service Kit for Series 2a-3

Adapter for Intake Manifold to Zenith or Weber Carburetor.Includes the Nuts and Locks for the Carburetor to the Adapter. Requires Gaskets EG-278163...

Fuel Filter for Series 3, LR 90/110 Gas, on Bulkhead or Rail For Series 3 2.25L Gas on Bulkhead, and Early Defender V8 & 2.5L Gas. For 2.25L, 2...

Fuel Filter - Diesel 2.25NA, 2.5NA, 2.5TD with Seals.For Series and Defender.Supersedes EF-517711, EF-90517711.

Everything you need to replace the Valve Cover Dome Nuts.... no, not donuts, dome nuts.

Knob for Gear Lever, Black Pancake Style Screw-On. For Series 1, 2, and 2a to 1971. Black "Pancake" shaped shift knob. Good quality, threaded plast...

Knob for Gear Shift Lever (Black, Push-On) for Late Series 2a and Series 3, 1968-84.This Requires the Knurl Ring Bushing GT-571661 to fit on the Sh...

Knob for 4WD Hi-Low Selector (Yellow) Series 1-3 1950-84

Knob for Transfer Lever (Red) Series 1-3 1953-84

Spring into action with this shifter spring for 4WD Hi-Low Selector Lever. For Series 1-3 trucks from 1950 through to the end of the run in 1984.

Gear Lever Grommet (Boot) for Series 1, 2, 2A and 3 ('50-'84)

Handbrake Lever Grommet (Boot) for Series 1, 1953-58.Note: Hole for Handbrake Lever is Round and Grommet is longer than later Series 2 to 3.

Handbrake Lever Grommet (Boot) for Series 2 and 2a, 1958-66.Note: Hole for Handbrake Lever is Round. For the later Series 2a/3 Grommet with the Ova...

Handbrake Grommet (Boot) Late Series 2a and Series 3, 1967-84. Hole is Oval Shaped for Handbrake Lever. Can work on Series 2 to 2A models, 1958-66,...

Transfer/Low Range Lever Grommet (Rubber Boot).Series 1-3 1953-84.Supersedes BG-303821.

Gearbox and Transfer Case Gasket Set - Series 1-3 1948-84

Bell Housing to Transmission Gasket S1-3, 48-84

Gearbox Bearing Kit for Series 1-2a, Suff A. This is a five piece kit that will fit trucks right from the beginning in 1948 up until 1963. Includes...

Gearbox Bearing Kit Series 2a Suffix B through to Series 3 Suffix A. From September of 1963 (when Land Rover changed the gearbox ratios) up to Sept...

Oil Seal, Front or Rear Output Shaft on Transfer Case of transmission, Series 1-3, 1948-1984.Fits every single Series truck. Keep it simple.

Oil Seal, Front or Rear Output Shaft, Corteco (OEM) Series 1-3, 1948-84. Every. Single. Series.

Transmission Hand Brake Expander Unit Series 2A-3, 1961-84. This expander unit requires 3 locking clips to hold it in place (BB-515467/0)

Hand Brake Expander Dust Cover for Series 2a and 3; 1964on. Also happens to fit Land Rover 90's, 110's, Discovery 1's, and Range Rover Classics... ...

Hand Brake Expander Locking Clip, Center.For Series 2a-3, (1964-84), Defender to VIN: LA935629 (1993), Discovery 1, and RRC to VIN: LA647644 (1993)...

Hand Brake Expander Locking Clip, Inner. For Series 2a-3, (1964-84), Defender to VIN: LA935629 (1993), Discovery 1, and RRC to VIN: LA647644 (1993)...

Hand Brake Expander Locking Clip, Outer.For Series 2a-3, (1964-84), Defender to VIN: LA935629 (1993), Discovery 1, and RRC to VIN: LA647644 (1993)....

Transmission Hand Brake Adjuster Unit, Series 2A-3, 1964-84

Radiator Hose Kit for late Series 2A and Series 3 (1968-1984) with the clamps. For 2.25L Gas or Diesel. Also Required if replacing your Radiator wi...

Bottom Radiator Hose, Late Series 2A and 3, 1968-1984, 4-Cylinder. For a Complete Kit of Hoses with Clamps, see EC-HOSEKIT3.