Newest Products

Output Shaft Front for Series 1 to 3 1948-84.Supersedes GT-233248.This item is Old New Stock.

Spring Oil Pressure Release Valve Series 1 1954-58

Exhaust Valve Seat Oversize .005.For Series 1 1.6L and 2.0L, 1948-58, and Series 2a 2.6L 6 Cylinder.

Pop Rivet Alum 3/16"x3/4" Max Clinch 1/2" Sealed End

Set of 20 Steel Lug Nuts. 16mm Metric. Fits Steel Rims on the Series 3 from 1971 through 1984, Defender to 2016, Discovery 1, and Range Rover Class...

Gasket Cork for Water Pump (8-Hole) Series 1-2, 2.25L Gas 1958-61, and 2.0L Diesel 1956-61.

Exhaust Clamp Bracket for Intermediate Pipe.For Series 1 to 3, Typically 2 Required.

Adapter for Wiper Arm 14.8mm Splined to 1/4" "D" Profile.Some Series 3 with the "D"-Profile Wiper Shaft. Also used on Defender up to VIN: 1A622423 ...

Pop Rivet Alum 3/16"x9/16" Max Clinch 5/16" Sealed End

OEM Adapter for Wiper Arm 14.8mm Splined to 1/4" "D" Profile.Some Series 3 with the "D"-Profile Wiper Shaft. Also used on Defender up to VIN: 1A622...

Engine Bay Decal Set for Series 2, 2a, 3

Engine Bay Decal Oil Bath Cleaner Instructions

Engine Bay Decal Air Cleaner "Wash Thoroughly…"

Engine Bay Decal "Lubricating Oil Use Only…"

Engine Bay Decal "Smiths" Heater

Engine Bay Decal "12V Lucas Coil"

Engine Bay Decal "Level Mark" Air Cleaner Oil Service

Bushing for Rocker Shaft 2.25/2.5L Gas to 110 Suff-B

Rocker Shaft OEM. For Series 2-3, 2.25L Gas or Diesel. Defender 2.5L Gas, Diesel, and Turbo Diesel. Supersedes EP-554070, EP-524841, EP-524839, EP-...

Bolt for Oil Pump Sprocket on TD5.For Defender or Discovery 2 with the TD5 Engine.OEM.

Bushing for Inlet Valve Rocker.For 1.6L and 2.0L Series 1, 1948-58.Land Rover Genuine.

Locker for Cam Thrust Plate Series 1 1.6/2.0 & S2a 2.6L

Rear Crankshaft Oil Retainer Seal Series 1 2.0L Gas 1955-58.

Rubber Washer for Rear Fuel Tank Mount.For Series 2-3 109" Station Wagon and Defender 110 or 130 to 1998, (to VIN: WA159806).4 Typically Required.F...

Wire Grommet for Flasher, Horn Lead and Other Uses, Black Rubber.Series 2-3, 1-5/16"OD, 1" Panel-Hole, 5/16" Wire Hole. 34.5mm OD, 27mm Panel-Hole,...

Fuel Pipe from Pump to Solex Carburetor For Series 2/2a 1958-68 For the Fuel Line that runs from the Tank to the Pump, see EF-552435 for Side Tank ...

Mounting Rubber for 200Tdi and 300Tdi Exhaust Systems.Defender 90/110/130, Discovery 1, and Range Rover Classic.OEM.

Defender 90 200Tdi Complete Exhaust System. Includes SE-ESR158 Front Down Pipe, SE-ESR358 Front Silencer Intermediate Pipe, SE-ESR254 Rear Silencer...

Square Washer for Series 2-3 109" Station Wagon Fuel Tank Mounts.Typically 4 Required.

Rubber Seal for the Bulkhead to the Windscreen.Series 1 80", 1948-53.

Vent Seals Kit Rubber Pair.For Series 1 86, 88, 107, or 109. 1954-58.

Rubber Seal for the Bulkhead to the Windscreen.Series 1 1954-58.

Rubber Seal for Windscreen to Roof.Series 1, 1954-58.Note: This does Not Include the Stiffening Metal Strip.

LOF Clutch Pedal Assist Kit Spring and Bushings. Defender 1994on Replace the old clutch pedal spring kit to assist the pressing of the clutch pedal...

LOF Power Clutch Slave Cylinder for TD5 Defender and TD5 Discovery 2. Heavy Td5 clutch pedal? This is a Cost-Effective Slave Cylinder that reduces ...

Clutch Release Bearing for LT77 and R380 with the 2.0L MPI Engine in Discovery 1, or the Italian Defender 90 with the 2.0L MPI Engine.Longer body c...

Dunkery 15" Heritage Wood Steering Wheel with 48-Spline Boss. The Dunkery 15” Wood Rim by Heritage 1948 has been developed around the classic spiri...

Plastic Seal Key Hole Trim for Anti-Burst Lock Barrel.OEMSeries and Defender.Supersedes DP-347151.

Rear Corner Protection Bumper Kit for Defender 90 or 110, PAIR.Heavy-Duty Rear Corner Protection With Fasteners.Note: These will not fit if you hav...

Lock Cylinders and Keys Pair for Series 3 Anti-Burst Door Handles. Used to replace the Cylinder Locks in the two front doors of a Series 3. For a s...

Inner Right Hand Mud Shield Splash Guard.For Late Series 2a & 3 Left Hand Drive Apr 1969 to '84Galvanized Steel, Made in the UK.

Inner Right Hand Mud Shield Splash Guard Heavy Duty GalvanizedFor Late Series 2a and 3 Left Hand Drive Apr 1969 to '84Hot-Dip Galvanized, Made in t...

Inner Left Hand Mud Shield Splash GuardFor Late Series 2a & 3 Left Hand Drive Apr 1969 to '84Galvanized Steel, Made in the UK.

Inner Left Hand Mud Shield Splash Guard Heavy Duty GalvanizedFor Late Series 2a & 3 Left Hand Drive Apr 1969 to '84Hot-Dip Galvanized, Made in ...

Seat Belt Anchor Bracket Front Lower Right and Left Hand, PAIR.Hot-Dip Galvanized. For Series 1-3, and Defender.

Clevis Pin for Tailboard Chain.For Series 1-3.This Requires Split Cotter Pin FS-3958L (linked below).

Bottom/Saddle Clamp for Intermediate Pipe Bracket 109 to SufB OEM