Series 1 Engine

Copper Washer for Oil Sump Drain Plug Series 1-3 And for Heater Control Adapter on Series 3 Crushable Copper Seal

Speedometer Cable for Series 1-2A (1950-1971)Note: You must keep and re-use the original Round Plate with 3 holes that mounts the cable to the tran...

Oil Pressure Switch for Series 1-3 2.0L, 2.25L, 2.6L, 4 and 6 Cylinder to 1984.

Hylomar Universal Blue Gasket/Jointing Compound 100g Non-Setting Joint Compound.

Front Crankshaft Oil Seal Corteco OEM Fits, Series 1, 1.6 and 2.0L Series 2, 2a, and 3, 2.25L 4Cyl and 2.6L 6Cyl Defender, Discovery 1 and RRC, 2.5...

Rear Crankshaft Oil Seal Kit with Retainer Halves Fits,Series 1 and 2 2.0L Diesel, 1957-59.Series 2, 2a, and 3 3 Bearing 2.25L Engine, 1958-84.Ser...

Rear Crankshaft Oil Seal, someimes referred to as the Rear Main SealFits,Series 1 and 2 2.0L Diesel, 1957-59.Series 2, 2a, and 3 3 Bearing 2.25L E...

Gasket OEM Paper for Oil SumpFor 4 cylinder 2.25L and 2.5L Gas, 2.0L and 2.25L Diesel.Supersedes EG-247088G.

Copper Sealing Washer Crushable for Various Uses. OEM.For Series 1-3 Oil Banjo Bolts, Series 2-3 Oil Pressure Sending Unit, Discovery 1, Discovery ...

Thermostat O-Ring Series 1 1.6/2.0L, S 2a-3 2.25L 1963-84

Castrol GTX Classic 20W50 Conventional Engine Oil 5 Litre Jug.For Series 1 to 3, 1.6L, 2.0L, 2.25L, 2.6L Gas and Diesel Engines.Castrol® GTX® Class...

Gearbox Mounting Rubber with Nuts.Series 1 Engine Mounts from 1954 to 1958 and Series 2/2a/3 Gearbox Mounts from 1958 up through 1984.

Gasket Paper for Oil Sump, aka Oil Pan GasketFor 4 cylinder 2.25L and 2.5L Gas, 2.0L and 2.25L Diesel.Supersedes EG-247088G.

Oil Filter for Series 1 2.0L Spreadbore Engine and Series 2a/3 6 Cylinder.Aftermarket.

Oil Filter for Series 1 2.0L Spreadbore Engine and Series 2a/3 6 Cylinder.Land Rover Genuine.

Frost Core Plug 1-7/8" Push-In Cup for 2.0L, 2.25L, and 2.5L Gas or Diesel (Side Plugs)Series 1 2.0L uses 4. Series 2-3 2.25L uses 3.

Starting Handle for Series Engines, (tool for timing) 1948-84.Make certain that your engine has the starting dog on the crankshaft.You might need t...

Front Crankshaft Oil Seal Fits, Series 1, 1.6 and 2.0L Series 2, 2a, and 3, 2.25L 4Cyl and 2.6L 6Cyl Defender, Discovery 1 and RRC, 2.5L NA Diesel,...

Locker Plate for Flywheel. For Series 1 1.6L and 2.0L, 3 are Required, 1948-58. For Series 2 to 3, 2.25L 3 Bearing and 2.6L, 3 are Required, 1958-8...

Copper Seal for Radiator Drain Plug or Drain Tap and 2.25L Engine Block Drain Plug or Drain Tap.</p>For Series 1-3.

Oil Pan Sump Drain Plug for 2.0L and 2.25L Engines. Series 1-3. 3/8" BSF Thread. Supersedes EP-3088. You May Require the Copper Seal, CS-243959 (li...

Fan Belt Toothed for Series 1 1.6L and 2.0L 1948-58.Sink your teeth into that!Supersedes FB-STC3673, FB-GFB40995.

Gasket For Front Timing Cover Joint. For Series 1-3, 2.0 Diesel, 2.25L Gas or Diesel, and Defender 2.25L Gas, 2.5L Gas or Naturally Aspirated Diese...

Round Retaining Plate with 3 Holes for Speedometer Cable. For Series 1 to 2a, (1950-1971). Fits on Speedometer Cable EP-RTC3484, holding it to the ...

Nut 1/4" BSF for Various Uses. For the Swivel Lock stop Bott, Yellow 4WD Knob, 4WD Clevis Assembly, Transfer Case Bottom Cover, Series 1 2.0L Intak...

Gasket Cork Thermostat Housing End Plate & Rear Cover for the 2.0L engine.

Lock Washer for Timing Chain Damper.For Series 1 2.0L, and Series 2-3 2.25L and 2.6L Gas.Two Typically Required.Supersedes EP-278769.

Original Cork Gasket for Oil Filter Housing to Block.Series 1 2.0L (Filter Housing to Adapter), Series 2-3, 2.25L and 2.6L.Defender 2.5TD and 200Td...

Camshaft Bearing Set 4-Cyinder, 1958-98.For 2.0L Diesel, 2.25L Gas or Diesel, 2.5NA, 2.5TD, 200Tdi and 300Tdi.Split Ring Style Bearings, for easier...

Gasket for Oil Filter Housing to Block Series 3 2.25L Gas or Diesel, and 2.6L, 1971-85, (See note below). Defender 2.5TD and 200Tdi, 1986-94. Super...

Gasket Cork for Oil Sump Series 1 1.6L or 2.0L 1948-58

Land Rover Genuine Gasket Cork for Rocker Valve Cover.For Series 1 1.6L and 2.0L Gas Engine, 1948-58.

Gasket Cork for Side Valve Cover.For Series 1 1.6L or 2.0L Gas Engine, 1948-58.

Hylomar 101 RTV Silicon Sealant Tube.85 Grams, For Gasketing/Sealing.

Valve Cover Dome Nut for Series 1 to 3, 2.25L Gas and 2.0L Diesel.For a Complete Kit of the Dome Nuts, Washers and Rubber Seals, see EP-DOMEKIT.

Gasket Cork Non-Adhesive Valve Cover.For the 2.0L and 2.25L Diesel Series 1 to 3, 1957 to 84.New Old Stock, OEM Made in the UK.Superseded by EG-ETC...

Packing Spacer for under Carburetor, (Solex).Series 1 1.6L and 2.0L 1948-58.

Split Cotter Pin 3/64" x 3/4" for Series 1 Solex Carburetor, Oil Strainer, Door Check Strap Clevis Pin, RRC Accelerator Pedal and Various Other Use...

Fiber Washer for Rocker Cover Bolts Series 1 1948-58.3 Required.

Sealing Washer O-Ring Side Rocker Cover for Series 1 2.0L 1954-58, Speedometer Pinion Sleeve Series 1-3 to 1984 and Series 2a 2.6L Water Pump. Mayb...

Gasket For Water Inlet.For Series 1 to 3, 2.0L Diesel, 2.25L Gas or Diesel, and Defender 2.25L Gas, 2.5L Gas and Naturally Aspirated Diesel, 2.5L ...

Lock Nut for Connecting Rod.Fits 2.0L Diesel, 2.25L Gas or Diesel, 2.5L Gas or Naturally Aspirated Diesel, or 2.5L Turbo Diesel.OEM. Made in the UK.

Mud Excluder for Front Crank Oil Seal Fits 2.25L Gas or Diesel, and 2.5L Gas. After drilling out the original rivets that hold the Mud Shield in pl...

Locker Plate for Timing Chain Wheel to Camshaft. OEM.For Series 1-3, 1948-84

Valve Seal Inlet Guide (O-Ring) 2.25L Gas up to March 1968, Engine Suff K Also on 2.0/2.25L Diesels up to 1968. Land Rover Genuine

Lock Washer for Starting Dog on Crank Series 1-3 1948-84 For 3 Bearing Engines

Bell Housing to Transmission Gasket S1-3, 48-84

Timing Chain for 1.6L, 2.0L and 2.25L Series 1-3 (3-Bearing) 1948-80.Supersedes EP-09156, EP-9156 and EP-504375.For the 2.6L 6 Cylinder, or the lat...