Series 1 Transmission

Solid copper washer for the drain plug on gearboxes and the transfer vase, fuel tanks, and rover differentials. For Series 1-3. Notes: 1.125" inner...

Pilot or Spigot Bushing for Flywheel. Series 1-3, 1948 through to end of TD5, Defender, Discovery 2Supersedes 8566L.

Oil Seal, Front or Rear Output Shaft, Corteco (OEM) Series 1-3, 1948-84. Every. Single. Series.

Speedometer Cable for Series 1-2A (1950-1971)Note: You must keep and re-use the original Round Plate with 3 holes that mounts the cable to the tran...

Gearbox and Transfer Case Gasket Set - Series 1-3 1948-84

Hylomar Universal Blue Gasket/Jointing Compound 100g Non-Setting Joint Compound.

Gearbox Mounting Rubber with Nuts.Series 1 Engine Mounts from 1954 to 1958 and Series 2/2a/3 Gearbox Mounts from 1958 up through 1984.

Oil Seal, Front or Rear Output Shaft on Transfer Case of transmission, Series 1-3, 1948-1984.Fits every single Series truck. Keep it simple.

Spring into action with this shifter spring for 4WD Hi-Low Selector Lever. For Series 1-3 trucks from 1950 through to the end of the run in 1984.

Gasket for Bottom of Transfer Case Series 1-3 1948-84

Tab Lock Washer for Rear Main Shaft Series 1-3 1948-84

Blanking Plug/Grommet for Bell HousingSeries 1, 2 and 2a to 1963

Transfer/Low Range Lever Grommet (Rubber Boot).Series 1-3 1953-84.Supersedes BG-303821.

Knob for Transfer Lever (Red) Series 1-3 1953-84

Grommet for Bell Housing Clutch Shaft Series 1-2a 1952-67 Up to Gearbox Suffix D April 1967. For the later Grommet, see BG-553262 (linked below).

Spring Clip for Transfer Gear Change Lever Series 1-3 1954-84

O-Ring Seal for Reverse Gear Selector Shaft.Series 1-3, 1955-84.Supersedes GT-272597.

Knob for 4WD Hi-Low Selector (Yellow) Series 1-3 1950-84

Oil Seal for Speedometer Pinion in GearboxSeries 1-3

Nut 1/4" BSF for Various Uses. For the Swivel Lock stop Bott, Yellow 4WD Knob, 4WD Clevis Assembly, Transfer Case Bottom Cover, Series 1 2.0L Intak...

Rubber Seal for Gearbox Selector Detent Spring 48-84

Locating Pin for 4WD Lever on Series 1-3, 1951-84

O-Ring Seal for Forward Gear Selector Shafts.Series 1 to 3, 1955-84.Typically 2 Required.Supersedes GT-241596, GT-237637.

Shim Washer for Rear of Gearbox Mainshaft.Series 1-3, 1948-84.

Brass Drain Plug for Differential, Fuel Tank or Transfer Case.For Series 1-3.Large Slotted Type. Requires Copper Washer GT-FRC4809.For a proper too...

Nut 7/16" BSF for Various Uses. OEM.For Series 1-3 Gearbox Bracket Mounts, Steering Levers Supersedes BN-594104. For Nyloc Version, see BN-251323. ...

Lock Nut for Rear Main Shaft Series 1-3 1948-84

Stud for Gearbox and Transfer Case 1-3/4" 1948-84

Peg for LT76 Gearbox Mainshaft Series 1-3, 1948-84 For the other Peg, see GT-RTC1979 (linked below).

Round Retaining Plate with 3 Holes for Speedometer Cable. For Series 1 to 2a, (1950-1971). Fits on Speedometer Cable EP-RTC3484, holding it to the ...

Sealing Washer O-Ring Side Rocker Cover for Series 1 2.0L 1954-58, Speedometer Pinion Sleeve Series 1-3 to 1984 and Series 2a 2.6L Water Pump. Mayb...

AVM Free Wheeling Manual Locking Hubs 10-SplineFor Series 1 through 3, to 1980 with 10-Spline Hubs.They're Back Baby! Easy to install, even easier ...

Collar for Under Spring of 4WD Lever Series 1-3.

Corteco OEM Oil Seal for Gearbox to Transfer Case Input Shaft.For Series 1-3.

Spring for Gearbox Reverse and Transfer Selector 1948-84

Rubber Gaitor for Overdrive Lever.For the Fairey or Global Roamer Over-Drive on Series 1-3.

Filler Plug for Swivel Housing Series 1-3. Also, for the Transfer Case Oil Level Plug Gearbox Suffix B on; 1/2" BSP.

Hylomar 101 RTV Silicon Sealant Tube.85 Grams, For Gasketing/Sealing.

Gasket Cork for Flywheel Timing Inspection Cover.For Series 1-3.

Anchor for Transmission Hand Brake Return Spring (on Transfer Case).Series 1 to 3, 1954-84.

Gearbox and Transfer Case Gasket and Seal Kit For Series 1-2 1948-61 Gasket Set with all Seals required for a full tear-down and rebuild. Includes ...

Mainshaft Bushing for 2nd Gear For Series 1-3 (This is 1 half of a two piece bushing, used with GT-FRC4077 linked below left) For the original 1 Pi...

Circlip for Gear Lever Series 1-3 1949-84

Split Ring Retainer for Series Gearbox Layshaft.For Series 1-2a, up to and including Suffix C, 1948-66.

Drain Plug or Wading Plug, 1/4" BSP Oil Level Plug for Transfer Case, Series 1 to 2a to Gearbox Suff A, (1962). Note some use 1/8" BSP Plug, SC-FTC...

Snap Ring for 2nd and 3rd Mainshaft Gears. Series 1-3 1948-84.Supersedes GT-6402 or GT-06402.

Handbrake Lever Grommet (Boot) for Series 1, 1953-58.Note: Hole for Handbrake Lever is Round and Grommet is longer than later Series 2 to 3.

All three Knobs and the Spring for your Series Gear Shift Set. Main Gear Lever (Black Screw-On type with Brass Insert - Pancake), Transfer Gear Cha...