Series 2 2a 3 Engine

Oil Filter for Series 1 2.0L Spreadbore Engine and Series 2a/3 6 Cylinder.Aftermarket.

Oil Filter for Series 1 2.0L Spreadbore Engine and Series 2a/3 6 Cylinder.Land Rover Genuine.

Oil Filter Long Early Type 6.8" Long by 3.75" Diameter.For Series 2-2a, 1958-1964 with Seal.Supersedes ES-248863.

Oil Filter Short Later Type Series 2a-3, 1964-1984 w/Seal.

Champion Brand Spark Plug. N9YC. For Series 2, 2a, and 3 with 2.25L or 2.6L engines with 7:1 Compression Ratio.

Carburetor Zenith 361V Replacement Series 2a-3 2.25L April 1967 to 1984.Note: To replace a Solex Carb on an earlier 2 or 2a, you are going to need ...

Weber 34ICH Carburetor Kit. Includes Choke Cable, Gaskets. Direct Replacement for Zenith Carburetor from April 1967 to 1984. To replace a Solex Car...

Weber 34 ICH Carburetor Service Kit for Series 2a-3

Adapter for Intake Manifold to Zenith or Weber Carburetor.Includes the Nuts and Locks for the Carburetor to the Adapter. Requires Gaskets EG-278163...

Distributor for 2.25L and 2.5L Engine - 45D4 Type Points.Complete with Rotor, Cap and Points. This is the later 45D type, suitable for all 2.25L en...

Electronic Black Cap Distributor for 2.25L/2.5L - 45D4 Type. Electronic Ignition with a Standard Look. This is the later 45D type, suitable for all...

Electronic Red Cap Distributor for 2.25L/2.5L - 45D4 Type.Ready to go Electronic Ignition. Red Cap to show that it is Electronic.This is the later ...

Water Pump Assembly Series 2A to 3, 2.25L.Gas or Diesel Engine, 9-Hole Pump with the Gasket.Note: This Does Not Fit the 1958 to 61 Series 2 Engine ...

Water Temperature Transmitter Sender Series 2-3, 2.25L 4-Cylinder and 2.6L 6-Cylinder

Oil Pressure Switch for Series 1-3 2.0L, 2.25L, 2.6L, 4 and 6 Cylinder to 1984.

Gasket Set for Top Overhaul 4cyl 2.25L Gas with Composite Head Gasket.If you are taking on a complete engine overhaul... a) good for you, and b) us...

Speedometer Cable for Series 1-2A (1950-1971)Note: You must keep and re-use the original Round Plate with 3 holes that mounts the cable to the tran...

Gasket Set for Bottom Overhaul - 4cyl 2.25L Gas.If you are taking on a complete engine overhaul... a) good for you, and b) use this with EG-STC1567...

Head Gasket Set for Top Overhaul 2.25L Diesel.Series 2a-3 1962-84.If you are taking on a complete engine overhaul... a) good for you, and b) use th...

Gasket Set for Bottom-End 2.25L Diesel, 1962-84.If you are taking on a complete engine overhaul... a) good for you, and b) use this with EG-STC1564...

Gasket Cork Non-Adhesive for Valve Cover 2.25L Gas Series 2-31958 onNote: That center strip gets cut out before you install the gasket. We can only...

Gasket Paper for Oil Sump, aka Oil Pan GasketFor 4 cylinder 2.25L and 2.5L Gas, 2.0L and 2.25L Diesel.Supersedes EG-247088G.

Gasket OEM Paper for Oil SumpFor 4 cylinder 2.25L and 2.5L Gas, 2.0L and 2.25L Diesel.Supersedes EG-247088G.

Timing Chain Kit for Series 2-3 2.25L Gas up to 1974

Timing Chain for 1.6L, 2.0L and 2.25L Series 1-3 (3-Bearing) 1948-80.Supersedes EP-09156, EP-9156 and EP-504375.For the 2.6L 6 Cylinder, or the lat...

Timing Chain for 2.25L Series 3 5-Bearing Engine 1980on, (Note: use with tensioner EP-ETC5190), 2.6L 6 Cylinder, and 2.5L Gas.For Earlier Chain, se...

Timing Chain Damper for 2.25L, 2.5L 2.6L Gas or 2.0L Diesel

Timing Chain Wheel for CamshaftSeries 2-3, 2.0L Diesel, 2.25L Gas or Deisel, 2.6L 6 Cylinder Gas.Requires Key EP-9210.

Everything you need to replace the Valve Cover Dome Nuts.... no, not donuts, dome nuts.

Piston Assembly Standard 2.25L Gas w/Rings & Gudgeon Pin

Piston Assembly 010" Oversize with Rings and Gudgeon Pin.For the 2.25L Series 2 to 2 and Land Rover 90/110.Bearmach New Old Stock. A little scruffy...

Piston Assembly 0.020" Over-Sized 2.25L Gas

Piston Assembly 030" Oversize with Rings 2.25L Gas Series 2-3

Piston Assembly 040" Oversize with Rings 2.25L Series 2-3

Piston Assembly 060" Oversize with Rings 2.25L Series 2-3

2.25L Gas Piston Ring Set Standard for One Piston OEM Hastings

2.25L Piston Ring Set per Piston .010 OS Gas For Series 2 through 3, 1958-84

2.25L Piston Ring Set per Piston .030 OS Gas For Series 2 through 3, 1958-84

Main Bearing Set Standard 2.25L Gas or Diesel 3-Bearing 1961-84.OEM King. For Seires 2a to 3.Note: Does not fit the Series 2 (1958-61) Engine.

2.25L Main Bearing Set .010 OS Gas or Diesel 3 Bearing 1961-84.Made in the UK.Note: Does not fit the Series 2 (1958-61) Engine.

Main Bearing Set .020 OS 2.25L Gas or Dsl 3 Bearing 1961-84. Note: Does not fit the Series 2 (1958-61) Engine. King Brand.

Connecting Rod Bearing Set Standard 2.25L Gas/Diesel 1961-84.For Series 2a to 3.Note: Does not fit the Series 2 (1958-61) Engine.

Connecting Rod Bearing Set .010 US 2.25L Gas/Diesel 1961-84. Note: Does not fit the Series 2 (1958-61) Engine.

Connecting Rod Bearing Set .020 US 2.25L Gas/Diesel 1961-84. Note: Does not fit the Series 2 (1958-61) Engine.

Crank Thrust Washer Standard Set.For All 4 Cylinder Engines up to 1998 (Excluding VM).

Crank Thrust Washer Standard Set, OEM.For All 4 Cylinder Engines up to 1998 (Excluding VM).

Core Plug 1" Threaded for 2.0L & 2.25L Engines.For Series 1 to 3. 2 Required for Series 1 1.6L and 2.0L, Series 2-3 2.25L 3-Bearing. Series 3 m...

Gasket for Choke Thermostat Cold Start Otter Switch on 2.25L Head