Series 2 2a 3 Transmission

Solid Copper Washer for Drain Plug on Gearbox and Transfer Case, Fuel Tanks, and Rover Differentials.For Series 1-3.Note: 1.125" ID 1.45" OD. Very ...

Speedometer Cable for Series 1-2A (1950-1971)Note: You must keep and re-use the original Round Plate with 3 holes that mounts the cable to the tran...

Set of 3 Replacement Rubber Grommets for Series 2a-3 1967-84.Handbrake, Gear, and Transfer Lever.Handbrake has Oval Hole. This set can work for ear...

Pilot or Spigot Bushing for Flywheel. Series 1-3, 1948 through to end of TD5, Defender, Discovery 2Supersedes 8566L.

Gearbox and Transfer Case Gasket Set - Series 1-3 1948-84

Oil Seal, Front or Rear Output Shaft, Corteco (OEM) Series 1-3, 1948-84. Every. Single. Series.

Handbrake Grommet (Boot) Late Series 2a and Series 3, 1967-84. Hole is Oval Shaped for Handbrake Lever. Can work on Series 2 to 2A models, 1958-66,...

Spring into action with this shifter spring for 4WD Hi-Low Selector Lever. For Series 1-3 trucks from 1950 through to the end of the run in 1984.

Hylomar Universal Blue Gasket/Jointing Compound 100g Non-Setting Joint Compound.

Blanking Plug/Grommet for Bell HousingSeries 1, 2 and 2a to 1963

Grommet for Bell Housing Clutch Shaft Series 1-2a 1952-67 Up to Gearbox Suffix D April 1967. For the later Grommet, see BG-553262 (linked below).

Gearbox Mounting Rubber with Nuts.Series 1 Engine Mounts from 1954 to 1958 and Series 2/2a/3 Gearbox Mounts from 1958 up through 1984.

Tab Lock Washer for Rear Main Shaft Series 1-3 1948-84

Gasket for Bottom of Transfer Case Series 1-3 1948-84

Set of 3 Replacement Rubber Grommets for Series 2/2a 1958-66. Handbrake, Gear, & Transfer Lever. Note: Handbrake has a Round Hole for Round Sha...

Locating Pin for Main Gear Lever Series 2-3 OEM

Shim Washer for Rear of Gearbox Mainshaft.Series 1-3, 1948-84.

Rubber Seal for Gearbox Selector Detent Spring 48-84

O-Ring Seal for Reverse Gear Selector Shaft.Series 1-3, 1955-84.Supersedes GT-272597.

Oil Seal, Front or Rear Output Shaft on Transfer Case of transmission, Series 1-3, 1948-1984.Fits every single Series truck. Keep it simple.

Transfer/Low Range Lever Grommet (Boot) Series 1-3 1953-84

Gearbox and Transfer Case Gasket and Seal Kit For Series 3. Gasket Set with all Seals required for a full tear-down and rebuild. Includes Front/Rea...

Gearbox and Transfer Case Gasket and Seal Kit For Series 2a 1961-71 Gasket Set with all Seals required for a full tear-down and rebuild. Includes F...

Oil Seal for Speedometer Pinion in GearboxSeries 1-3

O-Ring Seal for Forward Gear Selector Shafts.Series 1 to 3, 1955-84.Typically 2 Required.Supersedes GT-241596, GT-237637.

Handbrake Lever Grommet (Boot) for Series 2 and 2a, 1958-66.Note: Hole for Handbrake Lever is Round. For the later Series 2a/3 Grommet with the Ova...

Knob for 4WD Hi-Low Selector (Yellow) Series 1-3 1950-84

Circlip for Gear Lever Series 1-3 1949-84

Locating Pin for 4WD Lever on Series 1-3, 1951-84

Spring Clip for Transfer Gear Change Lever Series 1-3 1954-84

Collar for Under Spring of 4WD Lever Series 1-3.

Spring for Gearbox Reverse and Transfer Selector 1948-84

Peg for LT76 Gearbox Mainshaft Series 1-3, 1948-84 For the other Peg, see GT-RTC1979 (linked below).

Knob for Transfer Lever (Red) Series 1-3 1953-84

Brass Drain Plug for Differential, Fuel Tank or Transfer Case.For Series 1-3.Large Slotted Type. Requires Copper Washer GT-FRC4809.For a proper too...

All three knobs and the spring for your Series shift set. Ride in style.

Nut 7/16" BSF for Various Uses. OEM.For Series 1-3 Gearbox Bracket Mounts, Steering Levers Supersedes BN-594104. For Nyloc Version, see BN-251323. ...

Gearbox and Transfer Case Gasket and Seal Kit For Series 1-2 1948-61 Gasket Set with all Seals required for a full tear-down and rebuild. Includes ...

AVM Free Wheeling Manual Locking Hubs 10-SplineFor Series 1 through 3, to 1980 with 10-Spline Hubs.They're Back Baby! Easy to install, even easier ...

Corteco OEM Oil Seal for Gearbox to Transfer Case Input Shaft.For Series 1-3.

Mounting Bracket for Gearbox RH Series 2-3

Rubber Gaitor for Overdrive Lever.For the Fairey or Global Roamer Over-Drive on Series 1-3.

O-Ring Seal for Hi-Lo Transfer Selector Shaft.For Series 1-3.Supersedes GT-265019 and GT-515572.

Bell Housing to Transmission Gasket S1-3, 48-84

Gear Lever Grommet (Boot) for Series 1, 2, 2A and 3 ('50-'84)

Knob for Gear Lever (Black, Push-On) Late Series 2a,3 68-84

Knob for Gear Lever, Black Pancake Style Screw-On. For Series 1, 2, and 2a to 1971. Black "Pancake" shaped shift knob. Good quality, threaded plast...

Nut 1/4" BSF for Various Uses.For the Swivel Lockstop Bott, Yellow 4WD Knob, 4WD Clevis Assembly, Transfer Case Bottom Cover, Series 1 2.0L Intake ...