Service & Hardware

Staple for Hood Strap on Rear Tub and on Windscreen Rail.For Series and Defender.You are Purchasing 1, not 10 as shown in photo.

Key Blank Series 2a and 3 Ignition and Anti-Burst Door Locks.FS Type LR Genuine.Not for Earlier BE-395141 Key Cylinder requiring a flat on one-side...

Key Blank for Series 1, 2 and 2a Ignition and Early Hook Type Door Lock Barrels. Single-Sided, Flat on One Side, Used with BE-395141 Key Cylinder (...

Key Blank For Range Rover Classic Ignition and Some Defender Cubby Boxes.

Key Blank Ignition Defender 1987-2017.All Defenders with Steering Column Lock.Aftermarket.Supersedes KB-STC4798, KB-AAU8276.

Key Blank Series 2a-3 Door & Upper Tailgate Latch FP Type

OEM Service Kit for 300Tdi Oil, Air, Fuel Filters, Washers.

Shim for door striker to body. For all Defender from 1987 onwards.

Nut M12-1.75 Metric for Defender Bulkhead to Chassis.For the Bolt, see BN-AYG500080.Note: You are purchasing 1, not 10 as shown in the photo.

Bolt 3/8" UNF x 1-1/4" HT for Front Flange LT230 See BN-DA1423 for Complete Kit of Front Proshaft Bolts and Nuts.

Galvanized Stays for Rear Sill/Wings PAIR,In Front of the Rear Tires on Series 2-3, 88 and 109". Left and Right Hand.

Bolt Kit for Swivel Ball Flange to Axle.This is an Axle Set; does both Left and Right Sides.Series 1-3, 1948-84.

Bolt Kit for Seal Retainer to Swivel Hub.This is an Axle Set; does both Left and Right Hand Sides.Series 1 to 3, 1948-84.

Bolt Kit for Front Stub Axle to Swivel Hub.This is an Axle Set; does both Left and Right Hand Sides.For Series 1-3, 1948-84.

Shim for Front Axle Shaft 0.75mm Defender, Discovery 1, and Range Rover Classic. OEM. Note: You are purchasing 1, not 5 as shown in the photo.

Bearing Grease 20ml Sachet for Hub Bearings

Hub Bearing and Oil Seal Kit Defender Rear up to 1993

Hub Bearing and Oil Seal Kit. Defender front up to 1993 OEM

Hub Bearing and Oil Seal Kit. For Defender Front up to 1993

Castle Nut for Halfshaft, Output Shaft and Differential Pinion.Requires Cotter Pin AD-PS608101L and Flat Washer AD-571922.

Bolt Kit for Galvanized Bumper CP-564704 to Chassis Series 2-3.

White Canvas Strip Only, Series 1-3, 1948-1984, (White Canvas).For Breakfast (Front Grill), under Bonnet (Hood).You will need fasteners FS-338380 (...

Complete Floor Bolt Kit 4 Cylinder Series 2-2a 1958-70Includes Correct Fasteners for Floor Panel to Rear, Center Tunnel, Cowel, Sills and Footwells...

Shim for Door Hinge (Both-Ends, New Style Hinges).For Series that have been replaced with the later Puma Hinges, and Defenders.

Plastic Seal for Door Hinge Bolts Door-Side Series 3, 90/110

Hinge Gasket for Door Hinge to Bulkhead Series 3 Def to 1997

Hinge to Door Screw 2" Long for Series 3 and Defender Hinges up to 2006, OEM This is the longer screw that holds the Hinge to the Door. For the sho...

Captive Nut Door Hinge to BulkheadFor Series 3 and Defender up to 1998, and earlier bulkheads repaired with New Door Posts.OEM. These are UNF Threa...

Hinge to Bulkhead Screw 1.5" Long for Series 3 and Defender Hinge, OEMThis is the shorter screw that holds the Hinge to the Bulkhead. For the longe...

Stainless Steel Front/Middle 4-Door Bolt KitFor Series 3 109" 5-Door Station Wagon, Defender 110 5-Door Station Wagon, and Defender 130 Crew Cab.In...

Rubber Buffer (Puck) for Spare Wheel on Bonnet Kit of 4. Series 1-3.

Shackle Bolt for Front-End of Front Spring and Front-End of Rear Spring 9/16" UNF For 88" and 109"

Shackle Bolt for Rear of Front Spring - 9/16" UNF 88/109

Shackle Bolt for Rear of Rear Spring - 9/16 UNF 88/107/109

Nylon Lock Nut for Shackle Pins 9/16" UNF

Everything you need to affix your door cards properly to your door.This kit does one door, either front, or middle, not the rear safari doors.That'...

Service Kit for 300Tdi Oil, Air, Fuel Filters, Washers

Universal Windshield Washer Bottle Kit, Complete with Built-in Pump.Includes Washer Pump, 3/16" Tubing, Mounting Bracket and Fasteners.

Vinyl Wing Protectors For Defender and Series - Pair. Suitable for Series 1, 2, 2a, 3, and Defender 90/110/130. For the Meticulous Mechanic.

Service Kit for Defender with 2.5NA Diesel and 2.5Turbo Diesel. Includes Oil, Fuel and Air Filters, and Copper Seal(s).

Emergency Bulb and Fuse Kit- Suitable for Discovery 1, Discovery 2(up to 2002), Range Rover Classic, Range Rover P38, and Defenders

Brake Hose Nut Metric 10mm Zinc Series 3, June 1980-84

Copper Washer 3/8" for Brake or Clutch HoseFor Series 1-3, 1954-1984.

Lock Washer Shake-Proof Int Tooth 7/16" for Series 1 Brake Hose & Series 2, 2a, 3 Clutch Hose.

Brake Pipe Clip Stand-Offs Plastic

Rubber Grommet for Brake Line P-Clamps 3/16"-1/4"

P-Clamp for Brake Lines.For Series 1-3 Single or Dual Line 3/16 and 1/4" Pipes.Supersedes BC-50640.

Brake Pipe Clamp 88 and 109 Double 3/16" Line Stainless Steel.For side by side 3/16" Brake and Clutch lines.