Service & Hardware

Whitworth Combination Wrench 8 Piece Set 1/8" to 9/16" w/Case

Seat Box Hasp for Locker Lid Series 2-3 1958-84 Short Hasp

Valve Cover Gasket for the 300Tdi Engine.For Defender, Discovery 1, RRC.

Cylinder Head Bolt Kit for 300Tdi.For Defender, Range Rover Classic, and Discovery 1.OEM.

Distributor Cap 2.25L 4 Cyl from Series 3 Eng Suffix D Land Rover Genuine

Barrel Locks and Keys 4 Sets for Series 3 and Defender Anti-Burst Pull-Up Door Handles. Matched Keys.

Striker for Anti-Burst Door Handle Defender 90/110/130 from AA270227(1987). OEMAll Front and Middle-Row Doors. Not for the Rear Safari Door.

Flange Head Bolt M8 x 85mm Various Uses OEM.Two required on 300Tdi Intake Manifold.

Spire Nuts for Floor Screws and Other Uses Package of 10

Spire Nuts for Floor Screws and Other Uses

Set of 3 Replacement Rubber Grommets for Series 1 1953-58. Handbrake, Gear, and Transfer Lever. Note: Handbrake has a Round Hole for Round Shaft an...

Land Rover Genuine Oil FilterFits 2.5 Gas or Diesel, 2.5 Turbo-Diesel,200Tdi, 300Tdi, and 3.5/3.9/4.0/4.2/4.6L V8-GasDefender, Discovery 1, Discove...

Plastic Clip for Bonnet Prop Single on TD5 Defender, D2 OEM

Set of 3 Replacement Rubber Grommets for Series 2a-3 1967-84.Handbrake, Gear, and Transfer Lever.Handbrake has Oval Hole. This set can work for ear...

Bolt Kit for Series 2, 2a and 3, 1969 to 84, Right and Left Hand Mud Shield Splash Guards. Correct Fasteners for Doing Both Sides for LHD and RHD. ...

Fuel Tank Bolt Kit for S2-3 109" Stn Wgn up to Stuff B -1969. Note this kit does not include all parts required. This replaces the bolts, nuts, was...

Set of 3 Replacement Rubber Grommets for Series 2/2a 1958-66. Handbrake, Gear, & Transfer Lever. Note: Handbrake has a Round Hole for Round Sha...

Service Kit for Td5 Oil, Air, Fuel and Rotor Filters, Washer. Defender or Discovery TD5, 1999 to 2006.

Washer Flat #10 x 3/4" 18-8 Stainless Steel

Screw Fuel Pipe & Sender to Tank Series 1 3BAx1/2"

Complete Floor Bolt Kit for Series 1 1954-58 86/88/107/109"

Floor Screws and Spire Nuts. Package of 10x FS-320045 and 10x FS-302532

Complete Floor Bolt Kit 4 Cylinder Series 3 1971-84Includes Correct Fasteners for Floor Panel to Rear, Center Tunnel, Cowel, Sills and Footwells, (...

Stud for Seat Strap and Various Uses OEM Notes: Uses Bolt: FS-78120, Lock: FS-WM702001L, Nut: FS-RTC608. For the Straps, see TS-331974 or TS-ETX381...

Headliner Fir Tree Fastener Black Various UsesDefender, Discovery 2, RR P38

Headliner Fir Tree Fasteners Light Grey Various UsesDefender, Discovery 2, RR P38

Catch Assembly RH Cab Rear Window and Hard Top Sides

Catch Assembly Latch LH Cab Rear Window and Hard Top Sides

Edge Clip for Interior Trim and Various - Defender OEM

Support for Door Striker Left Hand Series 109", and all Defenders, OEM. For the Right Hand Support Bracket see BP-MWC1736.  

Nut Plate for Defender Roof, (6 Required - Front of Roof to Windscreen), or Bench Seat Belts Series 1-3.Supersedes BP-334177 and BP-MTC3203.Note: Y...

Bonnet Striker Pin Assembly for Early Defender, (Hand Controlled Catch Release), and Series 3 109 V8Land Rover Genuine

Bracket for Sill Panel Mount Defender 90/110/130

Nut Plate for Rear Body to Chassis Mount Series 1 to 3 and Defender to 2002. OEM. 5 Typically Required. Requires 2x Split Rivet RV-RB610082 and 2x ...

Center Catch for Seat Base Lids 90/110 and Various OEM

Clip for Bonnet Prop Rod Solid Defender to WA159806 OEM You are purchasing 1, not 5 as shown in the photo

Bracket for Side Panel to Tub, Rear.For Series and Defender.Land Rover Genuine.Supersedes BP-338552, BP-LR010907.

These are the fasteners necessary for fitting the bumper end caps (CP-DPT100070) on the Defender. You'll need four per cap, so eight in total. The...

Stainless Steel Front Vent Hinge Pin Kit (Set of 4) Notes: For Welded On Hinges. 4 Required per Bulkhead. For Series 2-3 and Most Defenders to 2007...

Special Stud for Mounting Hard Top Side Panels on Series 2-3 109" and Defender 110.Supersedes BP-338740 and BP-MRC9833.For the Stud used on Series ...

Bonnet Striker Pin with Spring Defender 1986 on

Hook for Top Drain Channel for Defender 90/110 from '86 OEM

Firtree Fastener White for Headliner Defender from 1988 OEM

Rivet Spat for Wheel Arches Defender and Various UsesFor a Package of 10, see BP-AFU1075-10. For Re-Usable Rivets see BP-AFU1075RU10.

Spring Clip for Tools behind Front Seats Series 1-3.For tools, like the hand crank, with a diameter up to 5/8".You'll need a rivet for installation...

Spring for Bonnet Catch RRC, D1, 90/110

Check Strap Bracket Front Door Series 3, 90/110 Rear 82-89

Hinge for Bonnet Right Hand Genuine Land Rover Galvanized Series 3 1972-84 For Left-Hand Hinge, see BP-345854 (linked below).