Service & Hardware

Hub Bearing and Oil Seal Kit Defender Rear up to 1993

Hub Bearing and Oil Seal Kit. Defender front up to 1993 OEM

Hub Bearing and Oil Seal Kit. For Defender Front up to 1993

Castle Nut for Halfshaft, Output Shaft and Differential Pinion.Requires Cotter Pin AD-PS608101L and Flat Washer AD-571922.

Bolt Kit for Galvanized Bumper CP-564704 to Chassis Series 2-3.

White Canvas Strip Only, Series 1-3, 1948-1984, (White Canvas).For Breakfast (Front Grill), under Bonnet (Hood).You will need fasteners FS-338380 (...

Complete Floor Bolt Kit 4 Cylinder Series 2-2a 1958-70Includes Correct Fasteners for Floor Panel to Rear, Center Tunnel, Cowel, Sills and Footwells...

Shim for Door Hinge (Both-Ends) Defender 90/110

Plastic Seal for Door Hinge Bolts Door-Side Series 3, 90/110

Hinge Gasket for Door Hinge to Bulkhead Series 3 Def to 1997

Hinge to Door Screw 2" Long for Series 3 and Defender Hinges up to 2006, OEM This is the longer screw that holds the Hinge to the Door. For the sho...

Captive Nut Door Hinge to BulkheadFor Series 3 and Defender up to 1998, and earlier bulkheads repaired with New Door Posts.OEM. These are UNF Threa...

Hinge to Bulkhead Screw 1.5" Long for Series 3 and Defender Hinge, OEMThis is the shorter screw that holds the Hinge to the Bulkhead. For the longe...

Stainless Steel Front/Middle 4-Door Bolt KitFor Series 3 109" 5-Door Station Wagon, Defender 110 5-Door Station Wagon, and Defender 130 Crew Cab.In...

Rubber Buffer (Puck) for Spare Wheel on Bonnet Kit of 4. Series 1-3.

Shackle Bolt for Front-End of Front Spring and Front-End of Rear Spring 9/16" UNF For 88" and 109"

Shackle Bolt for Rear of Front Spring - 9/16" UNF 88/109

Shackle Bolt for Rear of Rear Spring - 9/16 UNF 88/107/109

Nylon Lock Nut for Shackle Pins 9/16" UNF

Everything you need to affix your door cards properly to your door.This kit does one door, either front, or middle, not the rear safari doors.That'...

Service Kit for 300Tdi Oil, Air, Fuel Filters, Washers

Universal Windshield Washer Bottle Kit, Complete with Built-in Pump.Includes Washer Pump, 3/16" Tubing, Mounting Bracket and Fasteners.

Vinyl Wing Protectors For Defender and Series - Pair. Suitable for Series 1, 2, 2a, 3, and Defender 90/110/130. For the Meticulous Mechanic.

Service Kit for Defender with 2.5NA Diesel and 2.5Turbo Diesel. Includes Oil, Fuel and Air Filters, and Copper Seal(s).

Emergency Bulb and Fuse Kit- Suitable for Discovery 1, Discovery 2(up to 2002), Range Rover Classic, Range Rover P38, and Defenders

Brake Hose Nut Metric 10mm Zinc Series 3, June 1980-84

Copper Washer 3/8" for Brake or Clutch HoseFor Series 1-3, 1954-1984.

Lock Washer Shake-Proof Int Tooth 7/16" for Series 1 Brake Hose & Series 2, 2a, 3 Clutch Hose.

Brake Pipe Clip Stand-Offs Plastic

Rubber Grommet for Brake Line P-Clamps 3/16"-1/4"

P-Clamp for Brake Lines.For Series 1-3 Single or Dual Line 3/16 and 1/4" Pipes.Supersedes BC-50640.

Brake Pipe Clamp 88 and 109 Double 3/16" Line Stainless Steel.For side by side 3/16" Brake and Clutch lines.

Brake Pipe Clamp Stainless Steel 88 and 109 Single 3/16" Brake or Clutch Line. Also used as a clip for roof lamp wire.

Automec Small Pipe Bender Tool for 3/16" Copper-Nickel Pipe Great tool for making the right bends when installing any of the 3/16" kits.

Dust Cap for Wheel Cylinder or Clutch Slave Bleed Screw pn: BB-556508. You are purchasing 1, not 10 as shown in the photo.

Bleed Screw for Wheel Cylinders, Series 1-3 1954-84, and 2/2a Clutch Slave.

Brake Drum Screw Series 1-3 1948-1984 Each.For a Package of 10, see BB-1510-10.

Hub Spanner Wrench for Hub Locking Nut 2-1/16" 52mm .For locknut FRC8700.

Swivel Hub Grease Sachet, 370 grams, sufficient for 1 swivel hub. Perfect solution for those leaky swivels. Not recommended if you wade through wat...

Spring into action with this shifter spring for 4WD Hi-Low Selector Lever. For Series 1-3 trucks from 1950 through to the end of the run in 1984.

Weber 34 ICH Carburetor Service Kit for Series 2a-3

Rubber Seal for Fuel Sender UnitFor 109 Station Wagon, Defender Side and Rear Tank to 1998.For the Twist Clamp, see EF-ARA1501L.

Clamp Ring for Fuel Sender For 109 Station Wagon, Defender Side and Rear Tank to 1998. For Rubber Seal, see EF-ARA1502L (linked below).

Fuel Tank Fitting Kit for 88/109R Side Fuel Tank (552174)

Starting Handle for Series Engines, (tool for timing) 1948-84.Make certain that your engine has the starting dog on the crankshaft.You might need t...

Complete Service Kit Ducellier Ignition Some Series 3's.Includes; ES-RTC3184 Oil Filter, EF-606168 Fuel Filter (in-line), 4x EE-RTC3570 Spark Plugs...

Complete Service Kit Lucas Sliding Points Late Series 3.Includes; ES-RTC3184 Oil Filter, EF-606168 Fuel Filter (in-line), 4x EE-RTC3570 Spark Plugs...

Complete Service Kit Lucas Fixed Points.Series 2a to 3, 1964-76.