Service & Hardware

Valve Cover Gasket for the 300Tdi Engine.For Defender, Discovery 1, RRC.

Cylinder Head Bolt Kit for 300Tdi.For Defender, Range Rover Classic, and Discovery 1.OEM.

Distributor Cap 2.25L 4 Cyl from Series 3 Eng Suffix D Land Rover Genuine

Door Lock Cylinder Barrels and Keys, 4 Sets, with 8 Matching Keys.For Series 3 Anti-Burst Handles, Defender Push-Button Handles and Rear Safari Doo...

Striker for Anti-Burst Door Handle Defender 90/110/130 from AA270227(1987). OEMAll Front and Middle-Row Doors. Not for the Rear Safari Door.

Flange Head Bolt M8 x 85mm Various Uses OEM.Two required on 300Tdi Intake Manifold.

Spire Nuts for Floor Screws and Other Uses Package of 10

Spire Nuts for Floor Screws and Other Uses

Set of 3 Replacement Rubber Grommets for Series 1 1953-58. Handbrake, Gear, and Transfer Lever. Note: Handbrake has a Round Hole for Round Shaft an...

Land Rover Genuine Oil FilterFits 2.5 Gas or Diesel, 2.5 Turbo-Diesel,200Tdi, 300Tdi, and 3.5/3.9/4.0/4.2/4.6L V8-GasDefender, Discovery 1, Discove...

Plastic Clip for Bonnet Prop Single on Discovery 2 and Defender from 1998-2106 OEM

Set of 3 Replacement Rubber Grommets for Series 2a-3 1967-84.Handbrake, Gear, and Transfer Lever.Handbrake has Oval Hole. This set can work for ear...

Bolt Kit for Series 2, 2a and 3, 1969 to 84, Right and Left Hand Mud Shield Splash Guards. Correct Fasteners for Doing Both Sides for LHD and RHD. ...

Fuel Tank Bolt Kit for S2-3 109" Stn Wgn up to Stuff B -1969. Note this kit does not include all parts required. This replaces the bolts, nuts, was...

Set of 3 Replacement Rubber Grommets for Series 2/2a 1958-66. Handbrake, Gear, & Transfer Lever. This Handbrake grommet does not fit Series 1 1...

Service Kit for Td5 Oil, Air, Fuel and Rotor Filters, Washer. Defender or Discovery TD5, 1999 to 2006.

Washer Flat #10 x 3/4" 18-8 Stainless Steel

Screw Fuel Pipe & Sender to Tank Series 1 3BAx1/2"

Complete Floor Bolt Kit for Series 1 1954-58 86/88/107/109"

Floor Screws and Spire Nuts. Package of 10x FS-320045 and 10x FS-302532

Complete Floor Bolt Kit 4 Cylinder Series 3 1971-84Includes Correct Fasteners for Floor Panel to Rear, Center Tunnel, Cowel, Sills and Footwells, (...

Stud for Seat Strap and Various Uses OEM Notes: Uses Bolt: FS-78120, Lock: FS-WM702001L, Nut: FS-RTC608. For the Straps, see TS-331974 or TS-ETX381...

Headliner Fir Tree Fastener Black Various UsesDefender, Discovery 2, RR P38

Headliner Fir Tree Fasteners Light Grey Various UsesDefender, Discovery 2, RR P38

Catch Assembly RH Cab Rear Window and Hard Top Sides

Catch Assembly Latch LH Cab Rear Window and Hard Top Sides

Edge Clip for Interior Trim and Various - Defender OEM

Support for Door Striker Left Hand Series 109", and all Defenders, OEM. For the Right Hand Support Bracket see BP-MWC1736.  

Nut Plate for Defender Roof, (6 Required - Front of Roof to Windscreen), or Bench Seat Belts Series 1-3.Supersedes BP-334177 and BP-MTC3203.Note: Y...

Bracket for Sill Panel Mount Defender 90/110/130

Nut Plate for Rear Body to Chassis Mount Series 1 to 3 and Defender to 2002. OEM. 5 Typically Required. Requires 2x Split Rivet RV-RB610082 and 2x ...

Center Catch for Seat Base Lids 90/110 and Various OEM

Clip for Bonnet Prop Rod Solid Defender to WA159806 OEM You are purchasing 1, not 5 as shown in the photo

Bracket for Side Panel to Tub, Rear.For Series and Defender.Land Rover Genuine.Supersedes BP-338552, BP-LR010907.

These are the fasteners necessary for fitting the bumper end caps (CP-DPT100070) on the Defender. You'll need four per cap, so eight in total. The...

Stainless Steel Front Vent Hinge Pin Kit (Set of 4) Notes: For Welded On Hinges. 4 Required per Bulkhead. For Series 2-3 and Most Defenders to 2007...