Best Selling Products

Gasket Set for Top Overhaul 4cyl 2.25L Gas with Composite Head Gasket.If you are taking on a complete engine overhaul... a) good for you, and b) us...

Fuel Pump Rebuild Overhaul Kit for Series 2-3 Notched Stem Shaft.This will NOT work with Slot-Type shaft fuel pumps. See second photo for more deta...

Floor Screws and Spire Nuts. Package of 10x FS-320045 and 10x FS-302532

Exhaust Manifold for 2.25L 4 Cylinder Gas, Series 2a-3, 1961-1984. Can be used to replace Series 2, 2.25L Gooseneck Exhaust Manifold and Front P...

Flasher Unit for Turn Signal 3-Pin.For Series 1-2a, 1954 - 1971.

Distributor Cap for 2.25L 4 Cylinder 1967-74 up to Series 3 Engine Suffix C, 25D4 Distributor.Can be Used In Place of Earlier EE-600328 Screw-In Ty...

2.25L 4 Cylinder Ignition Lead Set Series 2a 1961-70 Push-In.Land Rover Genuine Longer Ignition Coil to Distributor Wire, for Coil located on Left-...

Ignition Contact Points Fixed for Series 1 to 3, 1954-76.Fits Series 1 Late Lucas DM2 LU 40504A Distributor, Series 2 to 3 Lucas 25D4 and 25D6 Dist...

Front Spring Shackle Plate Plain (1956-1984) 88"/109"

Wire Grommet for Frame Harness in Chassis.For Series 1 to 3, 1948 to 84.Note: Typically you need 2, one at each end...1 5/8"OD, 1 1/4"panel-hole, 1...

Wheel Hub Assembly with Studs Front and Rear Series 2a frm 1970 and Series 3 up to September, 1980. Does not fit the Stage 1 109" V8. Uses AW-RRD50...

Wheel Nut 15/16" Wide Series 1/2/2A, 1948-1969 Double-End.For a set of 20 Nuts, see AW-217361-20.For the Later 1-1/16" Wide Single-End Nut, see AW-...

Water Pump Assembly Series 2A to 3, 2.25L.Gas or Diesel Engine, 9-Hole Pump with the Gasket.Note: This Does Not Fit the 1958 to 61 Series 2 Engine ...

These shoes are made for wal... uh, stopping. Pair of Delphi Transmission Handbrake Shoes for Series 2a-3 from 1964 through to the end of 1984.

Toggle Switch for Dash, Interior, Wipers, and Other Uses.Single Pole Single Throw. Series 1-3.

Tab Lock Washer for Rear Main Shaft Series 1-3 1948-84

Intake to Exhaust Manifold Stud Kit (Studs, Locks, Nuts, and Gasket),For Mounting the Intake Manifold to the Exhaust Manifold on Series 2-3 Gas Eng...

Exhaust Manifold Stud for 1.6/2.0/2.25L 4 Cyl Gas or Diesel For Manifold to Exhaust Down Pipe

Spring into action with this shifter spring for 4WD Hi-Low Selector Lever. For Series 1-3 trucks from 1950 through to the end of the run in 1984.

Shim Washer for Rear of Gearbox Mainshaft.Series 1-3, 1948-84.

Set of 4 Series Hub Caps, Metal Silver.Used up to Sept 1983.

Radiator Bottom Hose Series 2 and Early 2A. 1958-1968. Petrol and diesel.

Oil Filter Short Late Type Series 2a-3, 1964-1984 w/Seal OEM

O-Ring Seal for Reverse Gear Selector Shaft.Series 1-3, 1955-84.Supersedes GT-272597.

Oil Seal for End of Front Axle Casing Series 1-3 1948-1984 OEM Cortego

Pinion Oil Seal for Rover Differential Front or Rear OEM For Series 1-3 1950-84l Supersedes AF-217507, AF-561360.

Oil Filter for Series 1 2.0L and Series 2a/3 6 CylinderLand Rover Genuine

Mahle Oil Filter for Defender TD5 and Discovery 2 TD5 Engines.

Locker for Stub Axle to Swivel Housing and Rear Brake Back Plate for every Series Truck.Supersedes AD-232416.

Brake Spring, Lower for 10" Shoes on 88" SWB For use on; Front 80/86/107/88" 10" Brakes up to June 1980. Rear 80/86/107/88" 10" Brakes up to 198...

Our vintage Land Rover ‘Field Service Kit’ is constructed in durable nylon with webbing straps, 2 layer felt appliqué LR Badge and two woven patche...

Hylomar Universal Blue Gasket/Jointing Compound 100g Non-Setting Joint Compound.

Key Blank Series 1 and 2a Ignition and Doors. Single-Sided, Flat on One Side, Used with BE-395141 Key Cylinder.

Ignition Coil Non-Resistor Type, 4 and 6 Cylinder 1967-84. Can be used on earlier models, if you have a push-in ignition lead. Used on Positive or ...

Ignition Condenser for Series 1-3, 1954-76.For the 2.0L, 2.25L 4 Cylinder, and the 2.6L 6 Cylinder.

Hinge Bushing for Hood (Bonnet),For Series 2a-3, 1972 on, Defender through to 2016,

Heater/Defrost Hose Kit for Kodiak 2/3 Series 2a-3. Clamps Included.These Hoses are the real thing; neoprene rubber over fiberglass re-inforced tex...

Genuine Set Wipac Lights for Series 2, 2A or 3 and Early Defender up to 1994.Light Kit. European Style, OEM, 73mm, 2-3/4" Lamps with bullet connect...

Gasket Kit with Seals for Transfer Case LT230For Defender, Discovery 1, and RRC. OEM.

Locking Hasp for Fuel Cap, (Gas or Diesel).Fits Series 2-3. (Fuel cap not included).

Accelerator/Gas Pedal Replacement Rubbe Series 2 to 3

Gasket Paper for Swivel Hub to Axle Case 1948-1984

Gasket for Stub Axle to Swivel Hub Front, Series 1 to 3, 1954-84

Front Spring Shackle Plate Threaded 9/16" UNF.Inner Shackle for Series 2a-3, 88" and 109", From March 1963, Suffix B on.

Dimmer (High-Low Beam), SwitchFloor Mounted Rear-Connections.

Cotter Pin for Halfshaft Nut, Rover Differential Flange, and Output Shaft. OEM. Note: You are purchasing 1, not 10 like shown in the photo.

Delphi OEM Wheel Cylinder Left Hand for Rear 10" Brakes.For Series 1, 2, 2a and 3, 86" and 88" 1954 to June 1980.

Delphi OEM Wheel Cylinder Right Hand for Rear 10" Brakes.For Series 1, 2, 2a and 3, 86" and 88" 1954 to June 1980.