Newest Products

This is an under the seat mounted fuel tank that suits both petrol and diesel 88" Series trucks from 1958 through 1984. Also fits 109" up until Au...

Fuel Tank Fitting Kit for 88/109R Side Fuel Tank (552174)

Fuel Filler Tube Hose for 88" & 109" Regular Side Tank. For Series 2-3 88" and 109" Side Fuel Tanks See EF-543764K for Hose with Clamps

Breather Hose for Side or Rear Fuel TankFor 88" and 109" Series 2-3, and Defender up to VIN: MA159806, (1983-98)Can also be used for the 109 Rear T...

Fuel Sender with Pickup Tube for 109SW Rear Tank Suff C on (Aug/74) Gas.Note: To Install you may require both a clamp ring (EF-ARA1501L) and a rubb...

Fuel Filler Tube Hose for 109" LWB Series 2-3 Rear Tank.Notes: Requires HC-TS52-12-SS and HC-TS32-12-SS Clamps (see below links).

Fuel Sender Unit Gas or Diesel Under Seat and Rear Tanks from 1967 until 1984.Series 2a-3, 88" 1967-84, 109" Station Wagons 1967-74 with Original R...

Fuel Tank Sender Unit, Gas, 88/109" Under Seat Tank 1967-84 OEMMade in the UKSeries 2a-3, 88" 1967-84, 109" Station Wagons 1967-74 with Original Re...

Clamp Ring for Fuel Sender For 109 Station Wagon, Defender Side and Rear Tank to 1998. For Rubber Seal, see EF-ARA1502L.

Rubber Seal for Fuel Sender UnitFor 109 Station Wagon, Defender Side and Rear Tank to 1998.For the Twist Clamp, see EF-ARA1501L.

Fuel Sender Unit for 109SW Rear Tank Suff C on (Aug/74) Gas. OEM.Note: To Install you may require both a clamp ring (EF-ARA1501L) and a rubber seal...

Fuel Gauge 12v Series 2a-3 1967-84 Negative Earth.Fuel Gauge and Fuel Sender need to match.This matches Senders EF-90560612, EF-623097 and EF-PRC3098.

Hose for Air Cleaner to Carburetor Elbow on 2.25L and 2.6LSeries 2 to 3.For the same Hose with Stainless Steel Clamps, see EF-517093K.

Speedometer Cable for Series 1-2A (1950-1971)Note: You must keep and re-use the original Round Plate with 3 holes that mounts the cable to the tran...

Water Pump for Series 1 Gas 1.6L or 2.0L Engines,1948-1958.

Water Pump Assembly Series 2A to 3, 2.25L.Gas or Diesel Engine, 9-Hole Pump with the Gasket.Note: This Does Not Fit the 1958 to 61 Series 2 Engine ...

Water Temperature Transmitter Sender Series 2-3, 2.25L 4-Cylinder and 2.6L 6-Cylinder

Oil Pressure Switch for Series 1-3 2.0L, 2.25L, 2.6L, 4 and 6 Cylinder to 1984.

Gasket Set for Top Overhaul 4cyl 2.25L Gas with Composite Head Gasket.If you are taking on a complete engine overhaul... a) good for you, and b) us...

Head Gasket Set for Top Overhaul 2.25L Diesel.Series 2a-3 1962-84.If you are taking on a complete engine overhaul... a) good for you, and b) use th...

Outer Pinion Bearing Front or Rear Rover Differential.Series 1 to 2A, 1948-64. Up to Axle Suffix A Inclusive. For later Diff Outer Bearing see AF-5...

Gasket Set for Bottom-End 2.25L Diesel, 1962-84.If you are taking on a complete engine overhaul... a) good for you, and b) use this with EG-STC1564...

Gasket Cork for Side Valve Cover.For Series 1 1.6L or 2.0L Gas Engine, 1948-58.

Land Rover Genuine Gasket Cork for Rocker Valve Cover.For Series 1 1.6L and 2.0L Gas Engine, 1948-58.

Gasket Cork for Oil Sump Series 1 1.6L or 2.0L 1948-58

Distance Piece Collar for Stub Shaft Front or Rear Axle Race for Hub Seal. OEM. Series 1-3 upto 1980 Series 1 Front Only up to 1956.

Gasket Cork Non-Adhesive for Valve Cover 2.25L Gas Series 2-31958 onNote: That center strip gets cut out before you install the gasket. We can only...

Gasket Paper for Oil SumpFor 4 cylinder 2.25L and 2.5L Gas, 2.0L and 2.25L Diesel.Supersedes EG-247088G.

Gasket OEM Paper for Oil SumpFor 4 cylinder 2.25L and 2.5L Gas, 2.0L and 2.25L Diesel.Supersedes EG-247088G.

Exhaust and Inlet Manifold Gasket - 4 Cylinder 2.25L Gas.For Series 2 to 3, and Defender 2.25 and 2.5L Gas Engines.

Gasket for the Inlet Manifold to the Exhaust Manifold.2.25L Gas Series 2-3 1958-84.

Timing Chain for 1.6L, 2.0L and 2.25L Series 1-3 (3-Bearing) 1948-80.Supersedes EP-09156, EP-9156 and EP-504375.For the 2.6L 6 Cylinder, or the lat...

Timing Chain for 2.25L Series 3 5-Bearing Engine 1980on, (Note: use with tensioner EP-ETC5190), 2.6L 6 Cylinder, and 2.5L Gas.For Earlier Chain, se...

Timing Chain Damper for 2.25L, 2.5L 2.6L Gas or 2.0L Diesel

Carburetor Zenith 361V Replacement Series 2a-3 2.25L 1968-84.Note: To replace a Solex Carb on an earlier 2 or 2a, you are going to need some additi...

Weber 34ICH Carburetor Kit.Includes Choke Cable, Gaskets.To replace a Solex Carb on an earlier 2 or 2a, you are going to need some additional parts...

Weber 34 ICH Carburetor Service Kit for Series 2a-3

Adapter for Intake Manifold to Zenith or Weber Carburetor

Fuel Filter for Series 3, LR 90/110 Gas, on Bulkhead or Rail For Series 3 2.25L Gas on Bulkhead, and Early Defender V8 & 2.5L Gas. For 2.25L, 2...

Fuel Filter - Diesel 2.25NA, 2.5NA, 2.5TD with Seals

Everything you need to replace the Valve Cover Dome Nuts.... no, not donuts, dome nuts.

Knob for Gear Lever, Black Pancake Style Screw-On.For Series 1, 2, and 2a to 1971.Black "Pancake" shaped shift knob. Good quality, threaded plastic...

Knob for Gear Lever (Black, Push-On) Late Series 2a,3 68-84

Knob for 4WD Hi-Low Selector (Yellow) Series 1-3 1950-84

Knob for Transfer Lever (Red) Series 1-3 1953-84

Spring into action with this shifter spring for 4WD Hi-Low Selector Lever. For Series 1-3 trucks from 1950 through to the end of the run in 1984.

Gear Lever Grommet (Boot) for Series 1, 2, 2A and 3 ('50-'84)

Handbrake Lever Grommet (Boot) for Series 1, 1953-58.Note: Hole for Handbrake Lever is Round and Grommet is longer than later Series 2 to 3.