Series 2 2a 3 Fuel

Breather Cap on Diesel Rocker Cover Series 2a/3. Can be used on 2.25L Gas Engines with EGR Tube Required. Note: Emissions Tube is 7/16", larger tha...

Carburetor Needle for Stromberg Carb B1FH (4104), Needle TypeFor all V8 Gas w/Stromberg Carbs 26D, 27D and 30D to 1624 97.RRC, 2 Required, For Engi...

Oil Filler Cap for Series 3 2.25L Eng 901, 904 Suff C-D and 2.6L Also Used on many North American Standard Series 3's upto 1974 with EGR.

OEM Fuel Filter In-Line Series All, V8 Breather Inline D1 RRC

Screw for Fuel Sender Unit 3BAx3/8" 6 Required Note: These only fit Original Tanks. New Fuel Tanks may require Metric M4x16 or SAE 6-40.

Fuel Pump Glass Sediment Bowl Retainer Clip

Inlet Liner for Carburetor 2.25L Gas Series 2-3, 1958-84.

Phenolic Block for Solex Carburetor or Adapter to Zenith or Weber Carburetor.For Series 2 to 3, 1958-84.

Fuel Filler Tube Hose for 88" & 109" Regular Side Tank with Clamps.For Series 2-3 88" and 109" Side Fuel Tanks.

Special Bolt for Fixing Fuel Tank 88, 109R & SW Frm Suf-B OEM

Fuel Sender Unit Under Seat Tank Negative Earth OEMMade in the UKSeries 88" and 109" Regular with Under Seat Side Tank, 1967-84Defender Station Wag...

Heater/Glow Plug for 2.5L Diesel, 2.5TD Turbo Diesel, and 5-Bearing 2.25L Diesel.

Heater/Glow Plug for 2.5L Diesel, 2.5TD Turbo Diesel, and 5-Bearing 2.25L DieselOEM Bosch/Wellman

Heater/Glow Plug for 2.0L & 2.25L Diesel EngineSeries 1-3, 1956-84

Washer Flat Valve Cover Dome Nut S2-3 2.25L & Diesel Lines OEM

Ball Joint Assembly for 2BA Threaded Accelerator Rods Series1-3, and Defender V8 Requires FS-RTC608 2BA Nut for Locking in Position

Bell Crank Rod Assembly Lever to Carburetor Series 2a-3 2.25L March 1963on and 2.6L.Final Connection to Solex, Zenith and Weber Carburetors.

Ball Joint for Accelerator Linkage BrassSeries 2-2a 1958-63 (upto Eng-Suff C)This is 1/4"-28 UNF Male and Female. Uses BN-NH604041L 1/4" UNF Nut fo...

Accelerator Control Rod Cross Shaft to Engine Ball-Joint TypeFor 1958 Series 2 with the 2.0L Spreadbore Engine.Threaded 2BA, 2-3/8" Long.See EF-AAU...

Nut 2BA Thread for Accelerator Rod Ball Joints and Various Other Uses.Supersedes FS-2247 and FS-3823.Note: You are purchasing 1, not 10 as shown in...

Seal Washer for Top of Series 3 Diesel Filter and Defender Sedimentor.

Gasket Set for Solex Zenith Stromberg 175CD CarburetorFor 2.6L 6Cyl and 3.5L V8

Otter Switch Choke Warning Light.For Series 2-3 Cylinder Head with Spade-Connector.Located on the Front of the 2.25L Cylinder Head. Activates the C...

Hose for Air Cleaner to Carburetor Elbow on 2.25L and 2.6LWith Stainless Steel Clamps - Ready to Install.Series 2 to 3.For the same Hose without Cl...

Hose Connector for Zenith or Weber Carburetor to Air Cleaner ElbowFor Series 2a-3 1968on, or earlier if converted to a Zenith or Weber Carb.If you ...

Fuel Pipe from Pump to Early Zenith Carburetor 1969-72This is only for the early Zenith Carburetors with the Female Nut and Olive on the Carburetor...

Fuel Filler Cap for Military/Auxilary Under-Seat Tank (For Old Style Tank EF-STC613. Requires Gasket EG-551743, Not Included.Note: These are New Ol...

Mahle Fuel Filter - Diesel 2.25NA, 2.5NA, 2.5TD with Seals

Gasket for Inlet Manifold to Phenolic Block and Block to Carburetor or Adapter.For Series 2-3, 1958-84Two Required for Solex Carburetor, Two Requir...

Gasket for Zenith or Weber Carburetor to AdapterSeries 2a-3.

Fitting Kit for Zenith or Weber Carburetor Series 2a-3.

Sponge for Top of Fuel Tank.For Series 2-3 88 and 109 with Side Fuel Tank, 1958-84, and Defender 110 with Side Tank, 1983-98, to VIN: WA159806. See...

Gasket Seal for Filler Neck Under-Seat Fuel Tank.Two Seals Required; One required between the sponge, (see EF-504233), and the tank, and one requir...

Torsion Spring for Bell Crank Accelerator Linkage.For Solex Carburetor, Series 2-2a, 1958-69.

Linkage Clip for Accelerator Rod (New Old Stock).For Series 2-3, 1958-84.

Union Nut for Fuel Filter on the 2.25L Diesel and Various Other Uses. OEM.