Series 2, 2a, 3

Oil Seal for End of Front Axle Casing 1948-1984 Series 1-3

Rotor Arm for Series 1 2.0L and Series 2-3 2,25L 4 Cylinder up to Series 3 Eng Suffix C 54-74.For Lucas DM2 & 25D4 DistributorsNot for Ducellie...

Radiator Cap for Series 2a-3 9lb Pressure Gas/Diesel. Includes Rubber Seal. Not for Series 1, Series 2 or Early Series 2a. See EC-217437 for Series...

Weber 34 ICH Carburetor Service Kit for Series 2a-3

Speedometer Cable for Series 1-2A (1950-1971)Note: You must keep and re-use the original Round Plate with 3 holes that mounts the cable to the tran...

Hose for Air Cleaner to Carburetor Elbow on 2.25L and 2.6LSeries 2 to 3.For the same Hose with Stainless Steel Clamps, see EF-517093K.

This is an under the seat mounted fuel tank that suits both petrol and diesel 88" Series trucks from 1958 through 1984. Also fits 109" up until Au...

Fan Belt Toothed for Series 2a-3 2.25L Gas 1961-84 or 2.25L Diesel 1963-84.

Bolts, Nuts and Washers for the Bulkhead to the Chassis.Fits Series 1 to 3, 1948-84.

Slotted Drain Plug Tool for Series, Defender, and RRC.Uses a 19mm or 3/4" Socket or Wrench.For use on the Slotted Drain Plug, AF-235592.So much eas...

Front Chassis Bushing for the Rear of the Front Spring. This goes through the Chassis Rail for the Front Spring's rear shackle assembly.For Series ...

Grommet for Bell Housing Clutch ShaftSeries 1-2a 1952-67 Up to Gearbox Suffix D April 1967. For the later Grommet, see BG-553262.

Wing Mirror Round 4 1/2" with Standard 6" Arm - PAIR.For Series 1 - 3

Brake Drum Screws Series 1-3 1948-1984 PACKAGE of 10.

Rubber Buffer between Bulkhead and the Bonnet.For Series 2-3 and Defender up to VIN: LA939975, (1994).See BG-MRC6270 for Under Bonnet Buffer (Defen...

Return Spring for Pedal (Clutch or Brake without the Servo)For Series 2-3 and Defender to 1994, (to VIN: LA939891).

Corteco Pinion Oil Seal Rover Differential Front or Rear.For Series 1-3 1950-84Supersedes AF-217507, AF-561360.

Champion Brand Spark Plug. N9YC. For Series 2, 2a, and 3 with 2.25L or 2.6L engines with 7:1 Compression Ratio.

PAIR of Front Vent Rubber Seal Series 2-3, Defender 90/110 (These are the fit to bulkhead type, with Grooves for the Vents to seal into).

Brake or Clutch Pedal Rubber Series 2-3

Adapter for Wiper Arm 14.8mm Splined for 1/4" Round Shaft.Series 1-3. Comes with an Allen Hex Key for Fitting.

Clutch Slave CylinderSeries 2 and 2A, 1958-71Mounts on the Right-Hand side of the transmission. For the later Series 3 Slave Cylinder, see CC-591231.

Hub Lock Washer.For Series 1-3, the whole run from 1948 through 1984.For Land Rover 90/110 and Defender Front Axles to VIN: KA930455, (1993) and Re...

Handbrake Grommet (Boot) Late Series 2a and Series 3, 1967-84.Hole is Oval Shaped for Handbrake Lever.Can work on Series 2 to 2A models, 1958-66, b...

Oil Pressure Switch for Series 1-3 2.0L, 2.25L, 2.6L, 4 and 6 Cylinder to 1984.

Solid Copper Washer for Filler/Level Plugs on Rover Differentials.For Series 1-2a. Also listed for some Gearbox and Transfer Case Drain plugs..Fits...

Mounting Pad between Rear Tub Floor and Cross-Braces6 Required for Series 1-3 86"/88" and Defender 90 8 Required for Series 2-3 109" Station Wagon ...

Blanking Plug/Grommet for Bell HousingSeries 1, 2 and 2a to 1963

Spring for Hand Brake Relay/Expander Return 1954-84

Rear Crank Oil Seal, someimes referred to as the Rear Main SealFits,Series 1 and 2 2.0L Diesel, 1957-59.Series 2, 2a, and 3 3 Bearing 2.25L Engine...

Floor Screws and Spire Nuts. Package of 10x FS-320045 and 10x FS-302532

Exhaust Manifold for 2.25L 4 Cylinder Gas, Series 2a-3, 1961-1984. Can be used to replace Series 2, 2.25L Gooseneck Exhaust Manifold and Front P...

Flasher Unit for Turn Signal 3-Pin.For Series 1-2a, 1954 - 1971.

Gasket Set for Top Overhaul 4cyl 2.25L Gas with Composite Head Gasket.If you are taking on a complete engine overhaul... a) good for you, and b) us...

Wheel Cylinder Repair Kit Axle Set.For Series 1-3, 10" Front or 11" Rear Wheel Cylinders 243296 and 243297. Also for Series 1 80" 1950-53 Front Axl...

Upper Brake Spring for 10" Shoes.For use on;Series 2a-3 Front 80", 86", 107", and 88" up to June 1980.Series 2a-3 Rear 80", 86", 107", 88" up to 19...