Series 2, 2a, 3

Axle U-Bolt Rear with NutsFor Series 1-3 86/88, 107/109 to end of 2a, Rover Axle4 Required.

Bolt for Rear Propshaft both ends, and Front Propshaft to Differential.Series 1-3. 8 Required for Rear, 4 Required for Front. For the other Front P...

Rubber Seal for Pickup Cab to Tub Bulkhead Series 2 to 3, 88/109, Defender to 1991

Engine Mounting Rubber with Nuts.For Series 2, 2a, 3 Engines, 2.25L and 2.6L, 1958-84.

Clutch Alignment Tool Series 1-3 for 9" & 9.5" Clutch Plates

Hub Bearing for Series 3 1980 on, Defender, RRC and D1, Timken. Supercedes: AD-RTC3429

Weather Seal and Filler Strip for Alpine Windows and Rear Cat-Flap Window.Series 1-3 1948 to 84 and Defender to 1989; With 5mm Thick Glass.Does 1 A...

Wiper Motor 2-Speed for Series 2a/3, Defender to 2002 Note: Does Not include the Drive Gear, WW-517646. Typically you re-use the original drive gea...

Haynes Series II,IIA and III Owners Workshop Manual.The Haynes Land Rover Series II, IIA and III Petrol & Diesel Manual features detailed photo...

Spare Tire Clamp Retainer & Fastener Kit. For Series 1-3 88" and 109" Regular/Pick-Up Rear Tubs. In behind the front seats.

Gearbox and Transfer Case Gasket and Seal Kit For Series 2a 1961-71 Gasket Set with all Seals required for a full tear-down and rebuild. Includes F...

Lucas Classic Sports Coil.For 2.25/2.5L 4 Cylinder Engines, Series and Defender.

Gasket for Fuel Sender Unit Gas Tank Series 1-3 (Fiber)

Choke Cable for Series 2a (Jan/67-71), Zenith & Weber

Whitworth Combination Wrench 8 Piece Set 1/8" to 9/16" w/Storage Case. Sizes: 1/8", 3/16", 1/4", 5/16", 3/8", 7/16", 1/2", 9/16" Manufactured from ...

Hard Top Seal Right Hand Side Panel to Roof Top Series 2-3, 88" and 109" Regular and Station Wagon Also for Early Land Rover 90/110 Regular and Sta...

Hard Top Seal Left Hand Side Panel to Roof Top Series 2-3, 88" and 109" Regular and Station Wagon Also for Early Land Rover 90/110 Regular and Stat...

Set of 3 Replacement Rubber Grommets for Series 2/2a 1958-66. Handbrake, Gear, & Transfer Lever. Note: Handbrake has a Round Hole for Round Sha...

Complete Floor Bolt Kit 4 Cylinder Series 3 1971-84Includes Correct Fasteners for Floor Panel to Rear, Center Tunnel, Cowel, Sills and Footwells, (...

Front Bumper Galvanized Series 2-3 With Bolt Kit

Spring Clip for Tools behind Front Seats Series 1-3.For tools, like the hand crank, with a diameter up to 5/8".You'll need a rivet for installation...

Turnbuckle for Seat Base Locker Lids for Series1-3

Rubber Buffer for Seat Back, Door Check and Side Steps (54-84). OEM

Horn Low Note 12v for Series 1-3 and all other models.For the High-Tone Horn, see BE-YEB10026.

The good old standard lug nut. This is a 16mm wheel nut (metric, my American friends). Fits the Series 3 from 1971 through 1984, Defender, and Di...

Hub Bearing and Oil Seal Kit OEM Fits Series 1, 1948 to 58, Front Axle. Fits Rear Fully-Floating Axles on 109", and 88" with the optional full floa...

Galvanized Stays for Rear Wing PAIR.Behind the Rear Tire. Series 2-3, 88 and109 Regular.

Fan Belt Toothed for Series 2a-3 2.25L Gas 1961-84 or 2.25L Diesel 1963-84.OEM Dayco.

Spire Nut for Front Grill Badge, Seat Box and Various Uses.For Series 2-3.

Oil Seal for Speedometer Pinion in GearboxSeries 1-3

Circlip for Gear Lever Series 1-3 1949-84

Locating Pin for Main Gear Lever Series 2-3 OEM

Peg for LT76 Gearbox Mainshaft Series 1-3, 1948-84 For the other Peg, see GT-RTC1979.

Lucas L798 Clear Reverse Lamp.For Late 2a and Series 3.Requires Bulb LB-90575220 (Not Included). You may also need the clips for the screws to go i...

Wiper Arms and Flat Blades Kit Left Park Series 1-2a 1954-66.Kit Includes 2x PRC2621 Right Hand (Left-Park) Arms, and 2x PRC1330F Flat Blades.Speci...

PAIR of Rear Axle Re-Bound/Check Straps Extended Length for 86/88"Particularly perfect for Parabolic Springs, which raise the car 1 to 2 inches.

Tie Rod End, Set of 4.2x Right and 2x Left Hand, with Steering Rod Clamp Kits.For Series 1-3 1948-July 74, Unthreaded Shoulders.

Gasket Copper-Clad for between Intermediate Pipe to Muffler Series 2-3, 88 and 109" Exhaust Systems. Also for Series 1 Front Pipe to Manifold and S...

Exhaust Manifold Stud Kit (3 Studs, locks, & brass nuts) 2.25L Gas 61-84 For Mounting Down Pipe to Manifold. (These are included in the Comple...

Exhaust Hanger Bracket Kit (3 Brackets) for Left Exit System 86/88" 1954-84 Pre-assembled, ready to bolt into position. Please check your chassis f...

Two Pin Gas CapSeries 2a-3 with Seal OEM. 1963-78.Also used on some Defender 110's

Window Channel Kit Sliding Side Windows 58-84 1-Side Only

Rear Light Guard PAIR Zinc with Stainless Steel Fasteners for Series 2-3. These Do Not Fit North American Standard vehicles with the 4" L833 Lucas ...

Captive Nut Door Hinge to BulkheadFor Series 3, Defender, and bulkheads repaired with New Door Posts.OEMFor the Hinge to Door and Hinge to Bulkhead...

Shackle Bolt for Rear of Front Spring - 9/16" UNF 88/109

Key Washer for Hub Bearing Series 1 Front, Series 2-3 Front & Rear.

Universal Windshield Washer Bottle Kit Series 1-3

Windshield Washer Pump 12 Volt.For Series 2a/3, Early Defenders and Early RRC. For systems with a separate Washer Reservoir.Supersedes WW-PRC3369