Series Body Hardware

Galvanized Stays for Rear Sill/Wings PAIR,In Front of the Rear Tires on Series 2-3, 88 and 109". Left and Right Hand.

Cotter Pin for Bottom of Shock Absorbers and Other UsesSeries 2-3 OEMAlso used for holding the rear Tailgate hinge in place.

Pop-Rivet Aluminium. 3/16"x1/2" Maximum Clinch 9/32" Sealed End, Aluminium Stem. For a Package of 10, see RV-78248-10 (linked below).

Spire Nuts for Floor Screws and Other Uses Package of 10

Bonnet Canvas Strip White w/Brass Split Rivets S 2/2a 58-71

Spire Nut for Front Grill Badge, Seat Box and Various Uses.For Series 2-3.

Nut Spire for Front Wing to Bulkhead Series 2-3, 90/110

Copper Washer for 7/16" Brake Hose BC-219824 Series 1 1948-53.Also used on Series 2/2a Banjo Bolt for Brake Master Cylinder LHD, and with Brake/Clu...

Washer Lock for 2BA Screws and TS-MSC4657 Studs and Various Other Uses. OEM. You are purchasing 1, not 10 as shown in the photo.

Bolt 1/4" BSF x 5/8" for Seal Retainer Plate to Swivel Hub. OEM.Series 1-3 You are purchasing 1, not 10 as shown in the photo.Supersedes BN-237140.

Nut 3/8" BSF Nylon Self Lock.For Swivel Flange to Axle Bolt, and Rear Stub Axle to the Axle.For Series 1 to 3.

Nut Nylon Lock 7/16" UNF Grade 8.For Upper or Lower Steering Arms to Relay, and Shock Bolts.Series 2 to 3, 1958-84.

Hinge to Bulkhead Screw 1.5" Long for Series 3 and Defender Hinge, OEMThis is the shorter screw that holds the Hinge to the Bulkhead. For the longe...

Plastic Lockut Nut for Grill to Radiator Series 3, Defender, Dash, Wing Vents, Various Uses OEM Note: You are purchasing 1, not 10 as shown in the...

Set of 6 Stainless Steel Door Hinge Pin Kits For Series 2-2a 1958-71. For Two Front and One 2-Hinge Rear Safari Door.

Set of 2 Stainless Steel Door Hinge Pin Kits For Series 2-2a, 1958-71. Does One Door. Front, Middle, or Rear 2-Hinge Safari Door.

Turnbuckle for Seat Base Locker Lids for Series1-3

Stainless Steel Screw for Radiator Shroud, Seats and other uses.#10 x 5/8" Pan-Head Slotted, Type B point.For Series 1-3.

Shim for Door Hinge (Both-Ends, New Style Hinges).For Series that have been replaced with the later Puma Hinges, and Defenders.

Lock Washer Shake-Proof Int Tooth 7/16" for Series 1 Brake Hose & Series 2, 2a, 3 Clutch Hose.

Brake Pipe Clip Stand-Offs Plastic

Brake Drum Screw Series 1-3 1948-1984 Each.For a Package of 10, see BB-1510-10.

Rear Body Nut Plate and Fasteners for Series and Defender to 2002.Plate is Aluminium with Stainless Nutserts, Bolts and Washers Stainless Steel, Ri...

Stud for Rocker Valve Cover 2.25L Gas.Series 2 to 2a, 1958 to 71.Note: Not for Series 3. See EP-TE605211L for Engine Prefix 901, 904 and 361, 364 ...

Battery Hold-Down J-Clamp Rod for Series Battery Boxes.7-1/2" Long Total, 5-3/4" to Thread.Requires BSF Threaded Wing Nut FS-250431 (linked below)....

Wing Nut for Battery J-Clamp Rod, Air Cleaner Clamp 1/4" BSF Thread. OEM.Note: You are purchasing one, not 10 as shown in the photo.

Locker Plate for Spring U-Bolts .For Series 1, 1948-51 with the Early Narrow 2.5" Wide Leaf Springs, (Supersedes SS-217261); and Series 1 to 2a, 19...

Bolt Kit for Front Stub Axle to Swivel Hub. This is an Axle Set; does both Left- and Right-Hand Sides. For Series 1-3, 1948-84.

Rope Tie-Down (U-shape) on Rear Tub for Canvas Top. OEM.Zinc Coated. For Series 1-3 and Defender. Requires 2 Rivets, RV-RU612373.

Bolt Kit for Seal Retainer to Swivel Hub.This is an Axle Set; does both Left and Right Hand Sides.Series 1 to 3, 1948-84.

Bolt for Bonnet Spare Wheel Carrier Mounting. OEM.1/2" BSF x 3" Long. Works with Clamp BP-347262.

Tailgate Hinge Kit for Series or Defender Bolt to Rear-Cross. OEM.

Screw 2BA x 1/2" for Series 2/2a Dash and Various Uses OEM Also for Fuel Cover Plate to Filler Series 2-2a.

Set of 3 Replacement Rubber Grommets for Series 1 1953-58. Handbrake, Gear, and Transfer Lever. Note: Handbrake has a Round Hole for Round Shaft an...

Stud Plate for Sill Channel to Bulkhead Series 2 and 3 You are purchasing 1 Stud Plate

Clamp Arm (Claw Hook) for Securing Hoop Stick to Tub.For Series 1-3 and Defender.

Floor Screw Acme Thread Series 1-3 and DefenderFor a Package of 10 Floor Screws see FS-320045-10 (linked below left), or a Package of 10 Screws and...

Washer Spring Lock 5/16" Medium-Split Yellow-Zinc.For Various Uses.

Bonnet Fastener Hook Kit Pair Including Bonnet Catches. For Series and Military. Quality Aftermarket Re-Production Set. Zinc Plated Hooks with Zinc...

Pair of Brackets for the Front Wings to Bulkhead. Series 2-2a, 1958-71. Includes Right-Hand BP-338652, and Left-Hand BP-338653. Hot-Dip Galvanized....

Bolt M6-1.0 x 20mm Stainless Steel Pan-Head Phillips.For Series 3 and Defender Mirror Arms to Hinges, (2 Required per Door/Mirror).You are purchasi...

Bolt for Seat Belt at Seat Box Anchor Bracket.For Series 2a and 3. Fastens the Seat Belt to the Lower Corner Brackets, SB-345100/1.Note: Typically ...

Split Cotter Pin 3/64" x 3/4" for Series 1 Solex Carburetor, Oil Strainer, Door Check Strap Clevis Pin, RRC Accelerator Pedal and Various Other Use...

Clevis Pin for Tailboard Chain.For Series 1-3.This Requires Split Cotter Pin FS-3958L (linked below).

Seat Belt Anchor Bracket Front Lower Right and Left Hand, PAIR.Hot-Dip Galvanized. For Series 1-3, and Defender.

Screw for L798 Reverse Lamp.For Late Series 2a and Series 3.2 Required per lamp.

Bolt 3/8" BSF x 1-3/8" for Swivel Lock Stop, Rear Brake Plate/Stub Axle, Lower Steering Arms to Swivel Housing up to '66, and Series 1 Flywheel Hou...

Bolt Kit for Swivel Ball Flange to Axle.This is an Axle Set; does both Left and Right Sides.Series 1-3, 1948-84.