Service & Hardware

Re-Usable Rivets for Wheel Arches Defender & Various UsesA Better Fit, Easier Installation and these are Removal and Re-Usable.Package of 10. T...

Cylinder Head Overhaul Kit for Series 3 1975 on, 2.25L GasEverything needed to do a Valve Job.

Cylinder Head Overhaul Kit for Series 2, 2a, 3 up to 1974, 2.25L GasEverything needed to do a Valve Job.

Timing Kit for 300Tdi Defender, Discovery 1, RRCTensioner, Gasket, Outer Seals, (1 for up to VA560898 and 1 for VA560897 on), and OEM Belt.

Timing Kit for 2.5D & 2.5TD DefenderOEM Tensioner, Belt, and Gaskets. OEM.

Pop-Rivet Aluminium. 3/16"x1/2" Maximum Clinch 9/32" Sealed EndPackage of 10

Support for Door Striker RH Series 109", Defender 90/110.

Pop-Rivet Aluminium. 3/16"x1/2" Maximum Clinch 9/32" Sealed EndFor a Package of 10, see RV-78248-10

Set Screw Metric M8 x 40mm Pan-Head For Bonnet Buffer Defender, OEM You are purchasing 1 screw not 10 like pictured

Stud 7/16" BSF for Bottom of Swivel Housing Series 2a-34 Required on Top from Feb 1962 to '66, or use later alternative Bolt, BN-237357.2 required ...

Special Stud For Swivel Housing 7/16"BSF Series 2a-3This Stud has a thicker non-threaded center. 4 Required for Top, February 1962-66. 2 required o...

Stud for Gearbox Brackets on Transfer Case Series 1-3 7/16" Whitworth and 7/16" BSF. Requires Nut BN-2096.

Tailgate Hinge Kit for Series or Defender Bolt to Rear-Cross OEM

Cylinder Head Bolt for TD5 Engine 12 Required Defender and Discovery 2 with TD5. For a Full Set of 12, see EP-ERR5384Kit

Set of 12 Cylinder Head Bolts for TD5 Engine Defender and Discovery 2 with TD5. For a Head Gasket Sets, see EG-DA2112G-EARLY or EG-DA2112G-LATER.

Mounting Stud for Truck Cab to Tub Series 2-3 and Defender to 1994. 2 Required. UNF Thread. OEM For Later see BP-MUC8928 (Metric) 1994on

Barrel Locks and Keys 5 Sets for Series 3 and Defender Anti-Burst Pull-Up Door Handles. Matched Keys.

Stainless Steel Antiluce Pin Kit for TailgateFor Series and Defender.Shiny Pair.

Copper Washer for Sump Plug Series 1-3 And Heater Control Adapter on Series 3 Crushable Copper Seal

Nut 1/4"-28 UNF Hex Nut Zinc Stainless Steel

Clutch Alignment Tool 2.5NA/TD,200/300Tdi Def/RRC/D1

Captive Nut for Defender Air Intake, early Defender Rear Door Trim and Various Uses OEM5 Required for BP-BTR6188 Side Air Intake Grill.

Carpet Stud Black for RRC, 90/110 Door Panel Stud to '88

Screw for Fuel Sender Unit 3BAx3/8" 6 Required Note: These only fit Original Tanks. New Fuel Tanks may require Metric M4x16 or SAE 6-40.

Stainless Steel Screw Set for Side Air Intake Defender Set 5For Side Air Intake BP-BTR6188For replacement Captive Nuts in Wing Panel see FS-AFU1926L

Hinge for Bonnet Left Hand Genuine Land Rover Galvanized Series 3 1972-84 For Right-Hand Hinge, see BP-345853.

Timing Kit for 200Tdi Defender OEM Contains Timing Belt, Tensioner, and Gaskets for Cover and Water Pump

Timing Kit for 200Tdi Defender Contains Timing Belt, Tensioner, and Gaskets for Cover and Water Pump

Service Kit for 200Tdi Oil, Air, Fuel Filters, Washers Allmakes

Set of 6 Stainless Steel Door Hinge Pin Kits For Series 2-2a 1958-71. For Two Front and One 2-Hinge Rear Safari Door.

Set of 2 Stainless Steel Door Hinge Pin Kits For Series 2-2a, 1958-71. Does One Door. Front, Middle, or Rear 2-Hinge Safari Door.

Stud Distributor Housing and 2.6 Manifold Mounting

Air Filter Defender TD5, Discovery 2 V8 and TD5, Rover Rover P38 V8 and 2.5L Turbo Diesel.OEM Mahle.

Gasket for the Oil Filter Adapter on the 300Tdi Engine.For Defender, Discovery 1, and RRC.

Fuel Filter for Defender TD5 and Discovery TD5.Allmakes

Twist on oil filter, for the Td5 engine (Defender or Discovery 2). Not a bad idea to lube the new filter seal with a dab of oil when fitting.

Rocker Valve Cover Gasket TD5.For Defender or Discovery 2 TD5 from 2A622424, (2002on). Aftermarket.For earlier TD5 up to 2001, see EG-ERR7094.

Windscreen Brackets Billet Aluminium Silver Pair.Defender.Silver Anodized Finish, with Gaskets and Bolts.Replace your corroded Defender windscreen ...

Bolt Hex Cap 3/8" BSF x 1.5" for LockStop Plate on 109 1-Ton

Hylomar Universal Blue Gasket/Jointing Compound 100g Non-Setting Joint Compound.

Air Filter Element for 200TDI Discovery 1 to 1992, RRC, Land Rover Genuine

Strap for Windscreen Inner Hinge Mount Defender Note: From JA912346 (1992). For earlier see BP-RTC6159.Supersedes: BP-MUC4290, BP-LR016671

Stainless Steel Front 2-Door Bolt Kit For Series 3 88" and 109" Regular or Truck Cab, Defender 90 and 110 Regular and Truck Cab. Includes Allan Key...

Whitworth 3/8" Drive Socket 7 piece Set 1/8" to 1/2" with Storage Rail Sizes: 1/8" 3/16" 1/4" 5/16" 3/8" 7/16" 1/2" Manufactured from Chrome ...

Whitworth Combination Wrench 8 Piece Set 1/8" to 9/16" w/Storage Case. Sizes: 1/8", 3/16", 1/4", 5/16", 3/8", 7/16", 1/2", 9/16" Manufactured from ...

Whitworth Combination Wrench 8 Piece Set 1/8" to 9/16" w/Case

Seat Box Hasp for Locker Lid Series 2-3 1958-84 Short Hasp