Defender Hardware

Seat Belt Anchor Bracket Front Lower Right and Left Hand, PAIR.Hot-Dip Galvanized. For Series 1-3, and Defender.

Bolt for Anti-Roll Bar (also called a Sway Bar) to Ball Joint Front or Rear for Defender 90, Discovery 1 and Range Rover Classic.Requires Metal-Loc...

Bolt for Anti-Roll Bar (also called a Sway Bar) to Ball Joint Rear for Defender 110/130.Requires Metal-Lock Nut BN-NV116041L and Washers SS-RYF5001...

Clip Double Pipes to Chassis for Fuel Lines.For Defender up to 2006 and Range Rover Classic.

Washer Special for Mounting Hard Top Side Panels.For Series 2-3 Station Wagons and Defender 110 Station Wagons.Supersedes BN-332293.

Washer Flat for Hard Top Side Panels and Various Uses.Series and Defender.

Bonnet Hinge Kit Aluminium Billet Black Pair.For Defender. With bolts and bonnet hinge bushings.

Bonnet Hinge Kit Aluminium Billet Black PairFor Defender. With bolts and bonnet hinge bushings.

Stainless Steel Bolts for the Defender's Rear Safari Door.Using these smart stainless steel replacement bolt and screw kits will prevent rust from ...

Bolt M10 Dbl Hex Hd Swivel Housing to Axle Case Defender OEM

Pop Rivet 1/8" Diameter x 1/4" Long, Aluminium with Aluminium Mandrel.For Various Uses on Series, Defenders, Discovery 1, and RRC.

Pan-Head Slotted Screw M6x20mm Defender Floor Fastener. OEM. You are purchasing 1, not 10 like shown in the photo.

Bolt for Rear Rover Axle & Bearing Cap Def frm LA930456. Note: You are purchasing 1, not 10 like shown in the photo.

Bolt M10 x 45 mm Front Mount of Defender Fuel Tank.OEM. Note: You are purchasing 1, not 10 like shown in the photo.

Bolt Bulkhead to Chassis Defender 90/110/130

Rubber Plug for Chassis Front Defender frm XA159807on

Stud M8 x 35mm Injector to Cylinder Head, Inlet Manifold, and other Various Uses.For Defender.

Bolt Metric M8 x 45 HT for Steering Column U-Joints. OEM.For the Nut that usually goes with this, see BN-NY108041L. Note: You are purchasing 1, no...

Bolt Flanged Head M8 x 50mm.Various Uses, OEM.

Nut Metric M8 Nylon Lock Zinc for Various Uses. OEM.

Spacer for Door Striker Defender OEM.You are purchasing 1, not 5 as shown in the photo.

Bolt Kit for 300Tdi Water Pump - 8 Bolts.Fits Defender, Discovery 1, and RRC 300Tdi.

Bolt Short for 300Tdi Water Pump M8x30 and Other Uses.For a kit of all 8 required bolts, see EC-3BCR248.

Washer Flat for Fuel Pump, Pick-Up, Fuel Sender, Defender Door Handles, and Various other uses. OEM.

Bonnet Prop Arm Folding Type for DefenderOEM. Made in the UK.

Bolt for Caliper M12 x 35mm.Fits Defender Front and Rear, Discovery 1, Discovery 2, RRC, and RR-P38.Check your application before ordering.Supersed...

Bolt For Disc (Rotor) to Hub Defender, RRC, D1 OEM.Normally 5 required per side.Supersedes: BN-AFU1180, BN-FTC1368, BN-UYG500030.

Bolt Flanged Head M10x50mm for Drive Member.Defender up to VIN: KA930455, (1993).For 1994 on, see BN-BX110095M.

Push Fastener for Dash Trim Defender Slate-Grey Land Rover Genuine.

Washer Flat M12 for Series or Defender Bulkhead to Chassis and Antiluce Tailgate Pins, Metric. Yellow Zinc.

Stainless Steel Bolt Kit for the Defender Bumper.Includes the Black Cover Caps. Does Not include the Special Tap Blocks, see BN-ALQ710040K for a Co...

Barrel Locks & Keys 2 Sets for Series 3, Defender Anti-Burst Pull-Up Door Handles. Matched Keys.

Bolt Kit for Front Suspension, Radius Arms and Panhard Rod Bolts.For Defender from VIN: 2A626646, (2002 onwards).

Bolt Kit for Front Suspension, Radius Arms and Panhard Rod Bolts.For Defender from VIN: XA159807 to 2A626645, (1999-2002).For later Defender see SS...

Bolt Kit for Front Suspension, Radius Arms and Panhard Rod Bolts.For Defender from VIN: LA930456 to WA159806, (1994-98). RRC 1992-94.For later Defe...

Bolt Kit for Front Suspension, Radius Arms and Panhard Rod Bolts.For Defender up to KA930455 (1993.)For later Defender see SS-DA7200.

Bolt Kit Rear Suspension Trailing Arms and A-Frame Bolts.For Defender from VIN: 9Axxxxxx (2009). For Metric Bushings.For earlier Defender see SS-DA...

Nutsert M6 for Mud Flaps to Chassis Rail and VariousLand Rover Genuine

Front Vent Hinge Pin for Welded On Hinges4 Typically Required. Series 2-3 and Defender up to 1998. OEM.For a Stainless Steel Pin Kit see BP-DA1179.

Washer Flat M8 Zinc for Various UsesFor Defender Check Straps.

Re-Usable Rivets for Wheel Arches Defender & Various UsesA Better Fit, Easier Installation and these are Removal and Re-Usable.Package of 10. T...

Pop-Rivet Aluminium. 3/16"x1/2" Maximum Clinch 9/32" Sealed EndFor a Package of 10, see RV-78248-10

Support for Door Striker RH Series 109", Defender 90/110.

Bolt for Drive Flange Member. OEM.For Defender from VIN: LA930456 (1994on), Discovery 1 1992on, and RRC. Note: You are purchasing 1, not 10 like s...

Set Screw Metric M8 x 40mm Pan-Head For Bonnet Buffer Defender, OEM You are purchasing 1 screw not 10 like pictured

Stud for Seat Strap and Various Uses OEM Notes: Uses Bolt: FS-78120, Lock: FS-WM702001L, Nut: FS-RTC608. For the Straps, see TS-331974 or TS-ETX381...

Tailgate Hinge Kit for Series or Defender Bolt to Rear-Cross OEM

Cylinder Head Bolt for TD5 Engine 12 Required Defender and Discovery 2 with TD5. For a Full Set of 12, see EP-ERR5384Kit