Series 2 2a 3 Engine

Bell Housing to Transmission Gasket S1-3, 48-84

Gasket for the Inlet Manifold to the Exhaust Manifold.2.25L Gas Series 2-3 1958-84.

Exhaust and Inlet Manifold Gasket - 4 Cylinder 2.25L Gas.For Series 2 to 3, and Defender 2.25 and 2.5L Gas Engines.

Gasket for Fuel Pump to Engine Block 2.25L Gas/Dsl S 2-3

Fuel Filter - Diesel 2.25NA, 2.5NA, 2.5TD with Seals

Adapter for Temperature Sender on Metric Cylinder Head. Series 3 from Engine 36123672B and 36407286B. 16mm Male to 5/8" UNF Female.

Tappet Assembly (Lifter) for Series 2-3 2.25L Gas or Diesel, and the 2.5L for the Land Rover 90/110.

2.25L Gas Piston Ring Set Standard for One Piston

Front Crank Oil Seal Fits, Series 1, 1.6 and 2.0L Series 2, 2a, and 3, 2.25L 4Cyl and 2.6L 6Cyl Defender, Discovery 1 and RRC, 2.5L NA Diesel, 2.5T...

Front Crank Oil Seal Corteco OEM Fits, Series 1, 1.6 and 2.0L Series 2, 2a, and 3, 2.25L 4Cyl and 2.6L 6Cyl Defender, Discovery 1 and RRC, 2.5L NA ...

Rear Crank Oil Seal, someimes referred to as the Rear Main SealFits,Series 1 and 2 2.0L Diesel, 1957-59.Series 2, 2a, and 3 3 Bearing 2.25L Engine...

Rear Crank Oil Seal Kit with Retainer Halves Fits,Series 1 and 2 2.0L Diesel, 1957-59.Series 2, 2a, and 3 3 Bearing 2.25L Engine, 1958-84.Series 2...

Starting Handle for Series Engines, (tool for timing) 1948-84.Make certain that your engine has the starting dog on the crankshaft.You might need t...

Starting Handle Dog for 3 Bearing Engines 1.6L, 2.0L, 2.25LFor Series 1, 2, 2a and 3, 3-Bearing Engines.Requires EP-247771 Lock Washer, (Not Includ...

Lock Washer for Starting Dog on Crank Series 1-3 1948-84 For 3 Bearing Engines

2.25L Piston Ring Set per Piston .040 OS Gas For Series 2 through 3, 1958-84

2.25L Piston Rings Engine Set .040OS OEM Mahle For Series 2 through 3, 1958-84 4 Piece Oil Scraper Ring Set

2.25L Piston Rings Engine Set .060OS OEM Mahle For Series 2 through 3, 1958-84 4 Piece Oil Scraper Ring Set

Lucas Classic Sports Coil.For 2.25/2.5L 4 Cylinder Engines, Series and Defender.

New Old Stock. Set of 4 Piston Rings for the 2.25L Gasoline Engine (Standard Compression). Series 2a & 3.

Stud Distributor Housing and 2.6 Manifold Mounting

Valve Guide Inlet Diesel 2.0L and 2.25L Series 1-2a Fits Diesels from 1956 through 1968.For O-Ring Seal see EP-247186.Supersedes EP-272206

2.25L Piston Ring Set Complete Engine Set .060 OS Gas For Series 2 through 3, 1958-84

Valve Seal Inlet Guide (O-Ring) 2.25L Gas up to March 1968, Engine Suff K Also on 2.0/2.25L Diesels up to 1968. Land Rover Genuine

Replacement Heater/Glow Plug for 2.25L Diesel Engine 1962-84. For Parallel Wired Glow Plugs.

Pulley for Alternator on Series 2a/3 2.6L 6 Cyl Engine

Fuel Pipe Tank to Pump 88/109 Forward Tank Series 2-3 1958-84For the Fuel Line that runs from the Pump to the Carburetor, see EF-557432, (for Solex...

Fuel Pipe Pump to Zenith Carburetor OEM For Series 3 1972-84, (or conversions from Solex to Zenith or Weber Carburetors).Made in UK You may also ne...

Fuel Pipe Short Connecting Fuel Line to Zenith Carburetor For Series 3 1972-84, (or conversions from Solex to Zenith or Weber Carburetors). You may...

Breather Cap on Rocker Cover 2.0/2.25L Gas Series 1-3. With Label. No Emissions Pipe. Fitted to Engines upto Prefix 901 & 904 Suff B. For Seri...

Breather Cap on Diesel Rocker Cover Series 2a/3. Can be used on 2.25L Gas Engines with EGR Tube Required. Note: Emissions Tube is 7/16", larger tha...

Starter Motor for 2.25L Diesel Series 3.

Head Gasket 2.25L Dsl, 2.5D, 2.5TD (Not Tdi)

Connecting Rod Assembly 2.25L Diesel Series 2a through to early Land Rover 90 and 110

Copper Washer for Sump Plug Series 1-3 And Heater Control Adapter on Series 3 Crushable Copper Seal

Engine Mounting Rubber with Nuts.For Series 2, 2a, 3 Engines, 2.25L and 2.6L, 1958-84.

Gasket for Oil Filter Housing to BlockSeries 3 2.25L Gas or Diesel, and 2.6L, 1971-85, (See note below).Defender 2.5TD and 200Tdi, 1986-94.Supersed...

Heater/Glow Plug for 2.5L Diesel, 2.5TD Turbo Diesel, and 5-Bearing 2.25L Diesel.

Heater/Glow Plug for 2.5L Diesel, 2.5TD Turbo Diesel, and 5-Bearing 2.25L DieselOEM Bosch/Wellman

Heater/Glow Plug for 2.0L & 2.25L Diesel EngineSeries 1-3, 1956-84

Washer Flat Valve Cover Dome Nut S2-3 2.25L & Diesel Lines OEM

Ball Joint Assembly for 2BA Threaded Accelerator Rods Series1-3, and Defender V8 Requires FS-RTC608 2BA Nut for Locking in Position

Bell Crank Rod Assembly Lever to Carburetor Series 2a-3 2.25L March 1963on and 2.6L.Final Connection to Solex, Zenith and Weber Carburetors.

Ball Joint for Accelerator Linkage BrassSeries 2-2a 1958-63 (upto Eng-Suff C)This is 1/4"-28 UNF Male and Female. Uses BN-NH604041L 1/4" UNF Nut fo...

Accelerator Control Rod Cross Shaft to Engine Ball-Joint TypeFor 1958 Series 2 with the 2.0L Spreadbore Engine.Threaded 2BA, 2-3/8" Long.See EF-AAU...

Nut 2BA Thread for Accelerator Rod Ball Joints and Various Other Uses.Supersedes FS-2247 and FS-3823.Note: You are purchasing 1, not 10 as shown in...

Gasket Set for Solex Zenith Stromberg 175CD CarburetorFor 2.6L 6Cyl and 3.5L V8

Locker Plate for Timing Chain Wheel to Camshaft. OEM.For Series 1-3, 1948-84